The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally. New Here? Click here to learn more and get started.
Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!
Hello, our business counterpart are asking for a change.They want this flow: (high level)Customer Call in.ICM routes it to CVPCVP (Authenticate, session variables, are retrieved ((account, etc.))Eventually customer is routed to AgentAgent talks with ...
I have an application using the CCMP API to create Persons and Agents. It polls until CCMP reports a "Ready" state indicating the synch to the UCCE back-end has been completed or my 60-second timeout occurs. Normally, this takes under 5 seconds. I al...
Hi, the core switch has several VLANs. Let's say the subnet of the management VLAN where all switches are located is 192.168.100.0/24. All VLANs on the core are separated in VRFs. Core switch is accessable by ssh and http from within the management V...
Hello,Does anybody knows how I can pass/allow just SCTP traffic between two different security zones?zone security ZONE_OUTSIDE zone security ZONE_INSIDEI also have an extended ACL in which it is not possible to allow only the sctp protocol. I only g...
Dear All, I was trying to setup dot1x environment with IBNS2 in cisco c9200 switch, but its wasn't success, its still facing authenticate failure, below is the full configure, just wonder anything wrong with the class map and policy map ...
Hi All, I need to have the proper understanding of the use of Native VLAN in the trunk switchport an Access point is connecting. My current understanding is the AP can not read DHCP IP address via a tagged port (can not read 802.1Q packets).Therefor...
I have looked all over and nothing I've found has worked. I have upgraded my CER publisher from 11.5 to 14 (heading to 15). Rather than attempting to upgrade the subscriber, which is on an M4 host, I want to build a new subscriber on my M6 host and c...
Hello, A direct simple question, Does Cisco Catalyst 3650 support ThousandEyes? If yes, what is the real benefit of using ThousandEyes over Netflow or any other monitoring tools offered by Cisco or any other vendor, especially in the DNA Center? Kind...
Hi.Recently I was upgrading a C4500E with SUP8. The software which was pushed was a cat4500e- version instead of cat4500es8. version.During task "mage Integrity Vertication", it is validatting the software with succes. Afterwards the switch was fail...
Hello, I have the configuration for one domain in Duo with authentication proxy working but the error 'the directory server credentials were rejected' in the configuration directory. The certificate is correct and when I run the config tool, there ar...
physically on the equipment, the following alarm is detected in the platform, the following error is observed I have searched and found no related information.could you guide me to know the reason for the alarm?
Hi, please could I check to see if anyone knows there is any access to be able to view the logs from attempted vManage webhooks (to see whether there were any that failed to go through). I can't find anything in the interface to show this, but I was ...
If we have smartnet contracts, Solution Support contracts and some Success Track Level 1 contracts. Am i able to show all contracts in CX Cloud? Is it automatically show or i need to import or trigger for it ?
I hat two crashes in my LAB with 17.9.4a an a HA-cluster. Crash situations: 1) After setting up AVC for policy profiles (Configuration > Service > Application Visibility) 2) Without config change on WLC. Only a new client connected to WiFi (used one ...