Devnet Learning Labs for Devnet associate 200-901 and DEVCOR 350-901

Hi I need help to find all relevant tracks, Modules and labs on devnet platform which can effectively help me in preparing for 200-901 & 350-901. Thank you in advance and all advices are very appreciated

AP C9124AXE-ROW don't activate RADIO (2.4 and 5 GHz.)

Hi guys!I have some Access-Point (AP) C9124AXE-ROW in Controlle Cisco C9800-L version 17.6.4.The problem is that some APs C9124AXE-ROW do not activate the radios interface (5and 2.4 GHz).The power of the APs is OK 60W.As far as I know, there is no in...

CS-2960x-48FPS-L switch boot loop

anyone to help with my switch, logging the following logs and rebooting automatically.before it reboots the syst and rps lights light amber and then the fan off the reboots!#model: CS-2960x-48FPS-L

IE-3300-8P2S POE ports stopped working.

The cameras connected to the ports were working fine, but suddenly they stopped working. I tried upgrading the firmware, but it didn’t help. Please assist.

BGP NVE interface source interface

Hello, I'm JJYRR.I'm asking because I want to know about NVE interface while studying BGP.Why do I specify the source-interface separately for the NVE interface even if I specify the update-source in the BGP configuration? @bgp, @nve, @Source-interfa...

Yangsuite is hung in IOS XE on Cat8kv environment

While attempting to load a yang model (Cisco-IOS-XE-vlan) from a set in the Netconf configuration area of Yangsuite, the application just hangs. I have no recourse. I've tried stopping and re-starting the Yangsuite container. That did not work. Here ...

branch office router to temrminate mpls line

folks, I have a small branch office (greenfield) and we want to connect it to our HQ via the MPLS line the site will have 100 users/PCs what Cisco router can I use to connect that branch office to HQ via MPLS? Thanks, 

Issue with my OSPF and connectivity

Hi I'm new to the community and networking so kindly bare with me,I'm currently doing an assignment for my university, OSPF Routing. I've not done routing before but the assignment is is such that they gave a bunch of subnets and asked us to use them...

what is the real trigger for spanning tree take effect?

greetings guys,sorry for raising this kind of old-school question.It seems it is usually said that whenever there is a physic loop, a spanning tree (whether 802.1d or 802.1w or whatever, as long as they are not disabled) will take effect and block so...

How are DSCP values set?

Hello,It's possible to identify QoS traffic based on DSCP values. For example, for the EF class, by using the command "match ip dscp ef". But, how is the correct DSCP value set for specific traffic?I know that with some applications, the user can hav...

Blocked from a site how do i unblock it

Inter-AS SR-MPLS option C with IOS-XE 17.13.01a

Hello All,I have a simple topology with a few XE routers running SR-MPLS in each ISIS domain. PE1 and PE2 are acting as ASBRs. Between PE1 and PE2, I’m running BGP-LU and VPNv4 AF.The issue I’m facing is that the label assigned by BGP-Labeled Unicast...

Air-CAP1532i-E-K9 SAP image download/ without service contract

Dear Community,I have go an AIR-CAP1532i-E-K9 Access Point with the lightweight image installed.I would like to install the SAP (autonomus) image.Since this AP is EOL and there is no active service contract, I was not able to download the SAP image f...