Buy or Renew
Buy or Renew
Welcome to the Community!
The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally.
New Here? Click here to learn more and get started.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
1988612members
1344878discussions

Trending Topics

Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!

Community Activity

Start a conversation

Multiple BGP Peering to same remote as

Hello, Trying to lab up a scenario but having issues establishing BGP Peering. We have an iBGP Peering (same ASN) between RA and RB, they both directly connected and peering is fine. There is a router RC directly connected to RA using different ASN (...

ashb928 by • Level 1
  • 55 Views
  • 2 replies
  • 0 Helpful votes

Associate service profile

Hello Im getting message when trying to associate service profile  iSCSI VLAN is not native in overlay vNICissue with boot order, possibly iSCSI vNIC not found or no targets configured for iSCSI vnic or same iSCSI vnic is used for both primary and se...

SASC by • Level 1
  • 24 Views
  • 0 replies
  • 0 Helpful votes

C9500-24Y4C Inoperable

I have a Cisco C9500-24Y4C that I setup a few days ago by creating a user and adding some vlans. I unplugged the switch and moved it to a separate desk to do further setup and testing with other devices. When I plugged it in the switch does not allow...

FTD rejecting SSL Cert from FMC

Hi All, Wondering if anyone has seen this problem.  Trying to register a 6.4 FTD with 6.4 FMC.  Logs on the FTD are showing errors with the FMC SSL certificate and the sftunnel is never established between the the two devices.  All devices are straig...

Dialer Interface Question

HiHow do I check that all is ok with a Dialer Interface which is using Chap for authentication, is there any basic commands I can run to check all is ok, also I notice that the Dialer Interface dosent get an IP Address and never has but it does get a...

Cisco C1000 and 9300L Switches

Ladies/Gents:I recently discovered that two of the switches on my network were sharing the same IP. My IT guy says it doesn't matter because the assigned IP is for switch management only and should not affect traffic. We do minimal configuration out ...

New Gears

Hello Fam,I bought some new Cisco Gears, Cat 2960S 48 Ports, Router C892FSP, and Firewall ASA5525-X. I have set up and configured the three devices and I was able to ping the router and the Firewall from the Switch. So the 3 devices can communicate n...

Paschal20 by • Level 1
  • 25 Views
  • 1 replies
  • 0 Helpful votes

Issue with my OSPF and connectivity

Hi I'm new to the community and networking so kindly bare with me,I'm currently doing an assignment for my university, OSPF Routing. I've not done routing before but the assignment is is such that they gave a bunch of subnets and asked us to use them...

potsy017 by • Level 1
  • 150 Views
  • 3 replies
  • 0 Helpful votes
Load more