Cisco Community

bridge-domain interface in Cisco IOS-XR

Hello Everyone,Hope all of you are doing fine. Recently I'm trying to make router routed interface into bridge interface so that I can send packet from PC1 to PC2 via same broadcasting bridge domain. I used iox-xr router for the LAB. My configuration...

Difference between ip vrf "word" and vrf defination "word"

I have an Analog Voice Gateway that I need to creare a vrf and this VG accepts these commands ip vrf "word" and vrf definition "word" and I really don't know the differences beyond that the first one is for IPv4 and the second one accept IPv4 and IP...

Especific voip model with wrong time

Hello, on my CUCM I have different models of voip phones (8865, 8811, 7821, 6921 and 3905). We recently detected that only the 3905 model displays a different time on its screen compared to the other models. The time displayed is one hour less than t...

NAT for CISCO SDWAN (2 Internet)

Hello Fellas,I'm new to this community. We deployed an SDWAN in our organization. Our set up was 2 Internet ,1 router edge. We configured NAT(1st Internet) but every time of failover (2nd internet take over) our NAT was working. We want that every t...

Web-auth not automatically redirecting

When i connecting in my SSID, no automatic redirect to https://1.1.1.1/ But when i enter url https://1.1.1.1 with my hands everything is ok working !1) ipconfig - correct2) DNS resolving - correct3) WLC-> controller -> interface -> Virtual -> ip addr...

EIGRP neighborship Packet Exchange

During EIGRP neighborship form process both router exchange the update packet and first packet is init and second update packets contain the routes. But my doubt is first R1 has send a update packet on multicast and then again it send unicast in the ...

Cisco SD-WAN traffic flow

Hi, Based on picture above, assuming that's cisco SD-WAN in DC. How cisco SD-WAN in DC serve the traffic from sd-wan branch? Will both device in DC be active-active? or only one will serve the traffic from branch? If the answer is active-active, how...

CG522-E system-ip with vManage template

What IP address should be set as the system-ip address in the vManage template? 1. The IP provided by the wireless sim provider?2. The IP to assign to the ENET interface of the CG522-E? ( for local management )3. The IP to be used on a SD-WAN VPN (...

Webex app and Webex Meet app- Which to use for streaming live event?

Dear Webex Experts and users,Just want to seek your expertise with regards to which app to use for a live streaming event. Webex app or Webex Meet app?thank you and best regards

Network Pritners not showing on Android or IOS Mobiles

Dear All, I am unable to view my network printers on my mobile device when connected through the Cisco AP 3802i with WLC 5508. However, when I connect using D-Link or TP-Link routers, the printers show up and I can print from my mobile. I’ve tried to...

FTD HA BREAK FROM FMC - deployment failed on standby

Hi support team,We have 2 FTD named EXT1 and EXT2. Before HA BREAKEXT1 - PRIMARY STANDBY READY EXT2- SECONDARY ACTIVE Now I did BREAK HA from FMC for the high availability. I'm able to see no connection on EXT1 but the previous active is now handlin...

How to use External Call Control Profile with Hunt Pilot in CUCM

Hello all, I'm using Hunt Pilot to use common voicemail in CUCM12.5.I want to use the External Call Control Profile, but found that it is not available on the Hunt Pilot.Is there any alternative? Thanks in advance.

C2960 stack low bandwidth

Switch Ports Model SW Version SW Image------ ----- ----- ---------- ----------1 52 WS-C2960X-48TS-L 15.2(3)E2 C2960X-UNIVERSALK9-M2 52 WS-C2960X-48TS-L 15.2(3)E2 C2960X-UNIVERSALK9-M3 52 WS-C2960X-48TS-L 15.2(3)E2 C2960X-UNIVERSALK9-M* 4 52 WS-C2960X...

IPV6 not being filtered

Hi,After playing with this all night, and reading most of the posts about it, I couldn't understand if IPV6 filtering (for openDns family) will work. I'll start from the end: when disabling ipv6 (https://support.opendns.com/hc/en-us/articles/22798888...

What is SFTP used for?

What is SFTP used for in Cisco, and in general networking? How often, what for? thanks

Exciting Updates: Cisco Community Badge Refresh

Meet the new Spotlight Awardees for May-July 2024. Who are they?

September Community Update

Community Activity