The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally. New Here? Click here to learn more and get started.
Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!
I would like to understand how the vulnerability reporting works in SNTC. Lately, I have been noticing something strange. Not sure, if it is a reporting issue or something that I am missing. For instance, the SNTC is reporting the following vulnerabi...
I am using a Cisco C1111 ISR w/ 2 L3 interfaces, 8 L2 interfaces. Interface Vlan601 currently has an IP address assigned to it. I would like to use DHCP to assign the IP address to this interface. However, when I change it to DHCP, the MAC address in...
Em redes Cisco, o gerenciamento do tráfego e das funções críticas de roteadores e switches é dividido em três planos principais: Management Plane, Control Plane, e Data Plane. Cada um desses planos tem uma função especifica na operação da rede e é fu...
Foro Ask Me Anything (del 3 al 11 de octubre de 2024) Este foro está dedicado a las preguntas relacionadas con el webinar "Cisco TrustSec a Fondo: Trbl de Extremo a Extremo en SDA y SD-WAN", del pasado jueves 3 de octubre de 2024. Revisen la grabaci...
I have an application using the CCMP API to create Persons and Agents. It polls until CCMP reports a "Ready" state indicating the synch to the UCCE back-end has been completed or my 60-second timeout occurs. Normally, this takes under 5 seconds. I al...
Hello,Does anybody knows how I can pass/allow just SCTP traffic between two different security zones?zone security ZONE_OUTSIDE zone security ZONE_INSIDEI also have an extended ACL in which it is not possible to allow only the sctp protocol. I only g...
Hello Team, I need some help, we need to know if we can move the policy nodes to admin-monitoring nodes? we have version 2.4, base and Device admin licenses installed, we are running on Virtual machines. Our Deployment: 1 primary admin-secondary moni...
Hello, I have a testing center in one of my buildings that often has 300+ students taking exams at the same time. They are not allowed to bring their bags or personal items into the room so they place their backpacks in cubbies along the outside wall...
My ap Is joined but l got errors with obb AP-model ap-air2802i-b-k9 wireless controller 9800-CL 17.9.4 [*04/20/2024 19:08:59.6159] Discovery Request sent to 192.168.178.150, discovery type STATIC_CONFIG(1)[*04/20/2024 19:08:59.6432] Discovery Reques...
Hello, our business counterpart are asking for a change.They want this flow: (high level)Customer Call in.ICM routes it to CVPCVP (Authenticate, session variables, are retrieved ((account, etc.))Eventually customer is routed to AgentAgent talks with ...
Hi, the core switch has several VLANs. Let's say the subnet of the management VLAN where all switches are located is 192.168.100.0/24. All VLANs on the core are separated in VRFs. Core switch is accessable by ssh and http from within the management V...
Dear All, I was trying to setup dot1x environment with IBNS2 in cisco c9200 switch, but its wasn't success, its still facing authenticate failure, below is the full configure, just wonder anything wrong with the class map and policy map ...
Hi All, I need to have the proper understanding of the use of Native VLAN in the trunk switchport an Access point is connecting. My current understanding is the AP can not read DHCP IP address via a tagged port (can not read 802.1Q packets).Therefor...
I have looked all over and nothing I've found has worked. I have upgraded my CER publisher from 11.5 to 14 (heading to 15). Rather than attempting to upgrade the subscriber, which is on an M4 host, I want to build a new subscriber on my M6 host and c...
Hello, A direct simple question, Does Cisco Catalyst 3650 support ThousandEyes? If yes, what is the real benefit of using ThousandEyes over Netflow or any other monitoring tools offered by Cisco or any other vendor, especially in the DNA Center? Kind...