Good day, dear all,I kindly request your assistance in analyzing a case of signaling failure for incoming calls from a PSTN SIP trunk.Call flow:Service Provider → SIP → FW DMZ → GW 2921 → FW LAN → CUCM → IP PhoneThere are two different scenarios:Scen...
Forum Posts
Re: CUCM 12.5For a certain population of DNs, I currently have ToD routing setup to send inbound calls to voicemail during on-shift hours and ring the phone during off-shift hours, and allow internal to internal calls all day, which is working as des...
I have been working with the Prime Collaboration Deployment tool in the lab trying various things with it. I like the concept of what it is supposed to do, but in practice it fails far more than it succeeds. Of note: 1. If a presence server is hoo...
Hello, we have multiple cisco cucm and need to report memory, disk, cpu usage, where I can find the right oid/mib, and in case the NMS not receive data how we can troubleshoot this issue from cucm
We are trying to get CUCM 15 DRS backups working in our lab environment for now. We set up OpenSSH on our Windows server and tried to point DRS to it but kept getting generic error messages about the SFTP connection failing. Performing a wireshark ca...
Team, I'm trying to install Cisco UCM Version 15. Link- https://www.cisco.com/c/en/us/support/unified-communications/unified-communications-manager-version-15/model.html As part of our internal compliance process, our Legal team has r...
Hi All,currently i am failing to install the Cisco Unified Communications Manager 15 touchless.I follow the instructions provided in this documentation:Touchless Installation Task Flow Allthough it is a bit confusing (At least for me), since the sect...
Dears I have a voice gateway problem. We have a voice gateway connect to PBX using FXS port, and the phone is connected to the PBX. The voice gateway have two SIP trunk to CUCM Pub & Sub, and there is a MGCP gateway that managed by the CUCM. The MGCP...
Hi, we have BE600o Vm installed long ago, and we have forgotten the password for this device and unable to login. can anyone help on this. thanks
Resolved! Qsig T-1 using MGCP Configuration
Hello All,I have a VG310 with a two port T-1 card installed. I have configured the Gateway as a MGCP in the Call Manager and using qsig. The Primary call manager shos registered and the other call managers show as backup ready in the VG310. I have...
Hello,We have an installation of CUC14 SU3 and we are getting the following error message when staff login for this one account.The maximum session limit for “User account name” has been reached. Logout one of the active sessions or contact Administr...
Hello , We are facing CALL DROP challenge as well as automatic activation of loudspeaker when answering calls. Extensions with this problems are 106,109 and 112.For other extensions , the issue happens very rare.Attached is running config .Pls go thr...
Resolved! CUCM v14(SU3) certificates regeneration
Hi, For mix mode cluster, before version 14 i know you need to update CTL file for CAPF, Call manager and TVS certificates and restart services with below order. Upload certificatesRun the utils ctl update CTLFile only on PublisherRestart services.Re...
I’m relatively new to Cisco technologies and have been working on configuring SIP trunking between a CUBE (Cisco Unified Border Element) and CUCM (Cisco Unified Communications Manager) and also between a CUBE (Cisco Unified Border Element) and the Se...
Hi everyone I have issue on CMC in which when we tried to put CMC code the "#" sign was only adding up to the end of CMC code. Example is CMC code: 12345 >> Submit >> 12345# Submit >> 12345##. We tested also removing the CMC code required on the rout...
