Cisco Systems Inc

User Login    


 
System Information
Connection Type: DHCP Current IP: 192.168.1.80
Host Name: wip310 Domain:
Current Netmask: 255.255.255.0 Current Gateway: 192.168.1.1
Primary DNS: 192.168.1.1 Secondary DNS:
Primary NTP Server: 0.it.pool.ntp.org Secondary NTP Server:
TFTP Server:
 
Product Information
Product Name: WIP310 Serial Number: ACC133804U1
Software Version: 5.0.12(12141857) Hardware Version: R03
MAC Address: 0026CB0E6479 Client Certificate: Installed
Licenses: None
 
Phone Status
Current Time: 2/28/2010 00:36:14 Elapsed Time: 00:06:29
Broadcast Pkts Sent: 0 Broadcast Bytes Sent: 0
Broadcast Pkts Recv: 0 Broadcast Bytes Recv: 0
Broadcast Pkts Dropped: 0 Broadcast Bytes Dropped: 0
RTP Packets Sent: 0 RTP Bytes Sent: 0
RTP Packets Recv: 0 RTP Bytes Recv: 0
SIP Messages Sent: 3 SIP Bytes Sent: 2028
SIP Messages Recv: 3 SIP Bytes Recv: 1667
External IP:
 
Ext 1 Status
Registration State: Failed Last Registration At: 0/0/0 00:00:00
Next Registration In: 826 s Message Waiting: No
Mapped SIP Port:
 
EXT 1 Call 1 Status
Call State: No Service Tone: None
Encoder: Decoder:
Type: Remote Hold:
Callback: Peer Name:
Peer Phone: Duration:
Packets Sent: Packets Recv:
Bytes Sent: Bytes Recv:
Decode Latency: Jitter:
Round Trip Delay: Packets Lost:
Packet Error: Mapped RTP Port:
Media Loopback:
 
EXT 1 Call 2 Status
Call State: No Service Tone: None
Encoder: Decoder:
Type: Remote Hold:
Callback: Peer Name:
Peer Phone: Duration:
Packets Sent: Packets Recv:
Bytes Sent: Bytes Recv:
Decode Latency: Jitter:
Round Trip Delay: Packets Lost:
Packet Error: Mapped RTP Port:
Media Loopback:
 
Downloaded Ring Tone
Status: Idle
Ring Tone 1: Not Installed
Ring Tone 2: Not Installed

 
System Configuration
Restricted Access Domains:
Enable Web Server: Web Server Port:
Enable Web Admin Access: Admin Passwd:
User Password:
 
Internet Connection Type
Connection Type:
 
Static IP Settings
Static IP: NetMask:
Gateway:
 
Optional Network Configuration
HostName: Domain:
Primary DNS: Secondary DNS:
DNS Server Order: Syslog Server:
Debug Server: Debug Level:
Primary NTP Server: Secondary NTP Server:

 
SIP Parameters
Max Forward: Max Redirection:
Max Auth: SIP User Agent Name:
SIP Server Name: SIP Reg User Agent Name:
SIP Accept Language: DTMF Relay MIME Type:
Remove Last Reg: Use Compact Header:
Escape Display Name: SIP-B Enable:
Talk Package: Hold Package:
Conference Package: Notify Conference:
RFC 2543 Call Hold: SIP TCP Port Min:
SIP TCP Port Max: CTI Enable:
 
SIP Timer Values (sec)
SIP T1: SIP T2:
SIP T4: SIP Timer B:
SIP Timer F: SIP Timer H:
SIP Timer D: SIP Timer J:
INVITE Expires: ReINVITE Expires:
Reg Min Expires: Reg Max Expires:
Reg Retry Intvl: Reg Retry Long Intvl:
Sub Min Expires: Sub Max Expires:
Sub Retry Intvl:
 
Response Status Code Handling
SIT1 RSC: SIT2 RSC:
SIT3 RSC: SIT4 RSC:
Try Backup RSC: Retry Reg RSC:
 
RTP Parameters
RTP Port Min: RTP Port Max:
RTP Packet Size: Max RTP ICMP Err:
RTCP Tx Interval: No UDP Checksum:
Symmetric RTP: Stats In BYE:
 
SDP Payload Types
AVT Dynamic Payload: INFOREQ Dynamic Payload:
G726r32 Dynamic Payload: G729b Dynamic Payload:
EncapRTP Dynamic Payload: RTP-Start-Loopback Dynamic Payload:
RTP-Start-Loopback Codec: AVT Codec Name:
G711u Codec Name: G711a Codec Name:
G726r32 Codec Name: G729a Codec Name:
G729b Codec Name: EncapRTP Codec Name:
 
NAT Support Parameters
Handle VIA received: Handle VIA rport:
Insert VIA received: Insert VIA rport:
Substitute VIA Addr: Send Resp To Src Port:
STUN Enable: STUN Test Enable:
STUN Server: EXT IP:
EXT RTP Port Min: NAT Keep Alive Intvl:
 
Linksys Key System Parameters
Linksys Key System: Multicast Address:
Force LAN Codec:

 
Configuration Profile
Provision Enable: Resync On Reset:
Resync Random Delay: Resync Periodic:
Resync Error Retry Delay: Forced Resync Delay:
Resync From SIP: Resync After Upgrade Attempt:
Resync Trigger 1:
Resync Trigger 2:
Resync Fails On FNF:
Profile Rule:
Profile Rule B:
Profile Rule C:
Profile Rule D:
Log Resync Request Msg:
Log Resync Success Msg:
Log Resync Failure Msg:
Report Rule:
 
Firmware Upgrade
Upgrade Enable: Upgrade Error Retry Delay:
Downgrade Rev Limit:
Upgrade Rule:
Log Upgrade Request Msg:
Log Upgrade Success Msg:
Log Upgrade Failure Msg:
License Keys:
 
General Purpose Parameters
GPP A:
GPP B:
GPP C:
GPP D:
GPP E:
GPP F:
GPP G:
GPP H:
GPP I:
GPP J:
GPP K:
GPP L:
GPP M:
GPP N:
GPP O:
GPP P:

 
Call Progress Tones
Prompt Tone:
Busy Tone:
Off Hook Warning Tone:
Ring Back Tone:
Call Waiting Tone:
Confirm Tone:
SIT1 Tone:
SIT2 Tone:
SIT3 Tone:
SIT4 Tone:
Holding Tone:
Conference Tone:
Secure Call Indication Tone:
Page Tone:
System Beep:
 
Distinctive Ring Patterns
Cadence 1: Cadence 2:
Cadence 3: Cadence 4:
Cadence 5: Cadence 6:
Cadence 7: Cadence 8:
 
Control Timer Values (sec)
Reorder Delay: Call Back Expires:
Call Back Retry Intvl: Call Back Delay:
Interdigit Long Timer: Interdigit Short Timer:
 
Vertical Service Activation Codes
Call Return Code: Blind Transfer Code:
Call Back Act Code: Call Back Deact Code:
Cfwd All Act Code: Cfwd All Deact Code:
Cfwd Busy Act Code: Cfwd Busy Deact Code:
Cfwd No Ans Act Code: Cfwd No Ans Deact Code:
CW Act Code: CW Deact Code:
CW Per Call Act Code: CW Per Call Deact Code:
Block CID Act Code: Block CID Deact Code:
Block CID Per Call Act Code: Block CID Per Call Deact Code:
Block ANC Act Code: Block ANC Deact Code:
DND Act Code: DND Deact Code:
Secure All Call Act Code: Secure No Call Act Code:
Secure One Call Act Code: Secure One Call Deact Code:
Paging Code: Call Park Code:
Call Pickup Code: Call UnPark Code:
Group Call Pickup Code: Media Loopback Code:
Referral Services Codes:
Feature Dial Services Codes:
 
Outbound Call Codec Selection Codes
Prefer G711u Code: Force G711u Code:
Prefer G711a Code: Force G711a Code:
Prefer G726r32 Code: Force G726r32 Code:
Prefer G729a Code: Force G729a Code:
 
Miscellaneous
Time Zone: Time Offset (HH/mm):
Daylight Saving Time Rule:
DTMF Playback Level: DTMF Playback Length:
Inband DTMF Boost:

 
General
Station Name: Voice Mail Number:
Enable SMS: SCA Barge-In Enable:
 
Supplementary Services
Conference Serv: Attn Transfer Serv:
Blind Transfer Serv: DND Serv:
Block ANC Serv: Call Back Serv:
Block CID Serv: Secure Call Serv:
Cfwd All Serv: Cfwd Busy Serv:
Cfwd No Ans Serv: Paging Serv:
Call Park Serv: Call Pick Up Serv:
ACD Login Serv: Group Call Pick Up Serv:
 
Ring Tone
Keypad Tone: Keypad Tone Volume:

 
General
Line Enable:
 
Share Line Appearance
Share Ext: Shared User ID:
Subscription Expires:
 
NAT Settings
NAT Mapping Enable: NAT Keep Alive Enable:
NAT Keep Alive Msg: NAT Keep Alive Dest:
 
Network Settings
SIP TOS/DiffServ Value: SIP CoS Value:
RTP TOS/DiffServ Value: RTP CoS Value:
Network Jitter Level: Jitter Buffer Adjustment:
 
SIP Settings
SIP Transport: SIP Port:
SIP 100REL Enable: EXT SIP Port:
Auth Resync-Reboot: SIP Proxy-Require:
SIP Remote-Party-ID: Referor Bye Delay:
Refer-To Target Contact: Referee Bye Delay:
SIP Debug Option: Refer Target Bye Delay:
Sticky 183: Set G729 annexb:
 
Call Feature Settings
Blind Attn-Xfer Enable: MOH Server:
Message Waiting: Auth Page:
Auth Page Realm: Conference Bridge URL:
Auth Page Password: Mailbox ID:
Voice Mail Server: State Agent:
CFWD Notify Serv: CFWD Notifier:
 
Proxy and Registration
Proxy: Use Outbound Proxy:
Outbound Proxy: Use OB Proxy In Dialog:
Register: Make Call Without Reg:
Register Expires: Ans Call Without Reg:
Use DNS SRV: DNS SRV Auto Prefix:
Proxy Fallback Intvl: Proxy Redundancy Method:
 
Subscriber Information
Display Name: User ID:
Password: Use Auth ID:
Auth ID:
Mini Certificate:
SRTP Private Key:
 
Audio Configuration
Preferred Codec: Use Pref Codec Only:
G729a Enable: G726-32 Enable:
Release Unused Codec: DTMF Process AVT:
Silence Supp Enable: DTMF Tx Method:
 
Dial Plan
Dial Plan:
Enable IP Dialing:

 
Call Forward
Cfwd All Dest: Cfwd Busy Dest:
Cfwd No Ans Dest: Cfwd No Ans Delay:
 
Supplementary Services
CW Setting: Block CID Setting:
Block ANC Setting: DND Setting:
Accept Media Loopback Request: Media Loopback Mode:
Media Loopback Type:
   



Copyright © 2008 Cisco Systems Inc. All Rights Reserved.