=~=~=~=~=~=~=~=~=~=~=~= PuTTY log 2014.12.20 14:20:51 =~=~=~=~=~=~=~=~=~=~=~= login as: admin ----------------------------------------------------------------------- Cisco Configuration Professional (Cisco CP) is installed on this device. This feature requires the one-time use of the username "cisco" with the password "cisco". These default credentials have a privilege level of 15. YOU MUST USE CISCO CP or the CISCO IOS CLI TO CHANGE THESE PUBLICLY-KNOWN CREDENTIALS Here are the Cisco IOS commands. username privilege 15 secret 0 no username cisco Replace and with the username and password you want to use. IF YOU DO NOT CHANGE THE PUBLICLY-KNOWN CREDENTIALS, YOU WILL NOT BE ABLE TO LOG INTO THE DEVICE AGAIN AFTER YOU HAVE LOGGED OFF. For more information about Cisco CP please follow the instructions in the QUICK START GUIDE for your router or go to http://www.cisco.com/go/ciscocp ----------------------------------------------------------------------- Using keyboard-interactive authentication. Password: Access denied Using keyboard-interactive authentication. Password: % Password expiration warning. ----------------------------------------------------------------------- Cisco Configuration Professional (Cisco CP) is installed on this device and it provides the default username "cisco" for one-time use. If you have already used the username "cisco" to login to the router and your IOS image supports the "one-time" user option, then this username has already expired. You will not be able to login to the router with this username after you exit this session. It is strongly suggested that you create a new username with a privilege level of 15 using the following command. username privilege 15 secret 0 Replace and with the username and password you want to use. ----------------------------------------------------------------------- HOB-2951-01>en Password: Password: HOB-2951-01#sh run Building configuration... Current configuration : 7316 bytes ! ! Last configuration change at 13:19:44 GMT Sat Dec 20 2014 by admin ! NVRAM config last updated at 13:24:03 GMT Mon Aug 18 2014 by admin ! NVRAM config last updated at 13:24:03 GMT Mon Aug 18 2014 by admin version 15.1 service timestamps debug datetime msec service timestamps log datetime msec no service password-encryption ! hostname HOB-2951-01 ! boot-start-marker boot-end-marker ! ! card type e1 0 0 card type e1 0 1 ! no aaa new-model clock timezone GMT 3 0 network-clock-participate wic 0 network-clock-participate wic 1 --More--  ! no ipv6 cef ip source-route ip cef ! ! ! no ip dhcp use vrf connected ! ! no ip domain lookup multilink bundle-name authenticated ! ! ! ! isdn switch-type primary-net5 ! password encryption aes crypto pki token default removal timeout 0 ! crypto pki trustpoint TP-self-signed-786894652 enrollment selfsigned subject-name cn=IOS-Self-Signed-Certificate-786894652 --More--   revocation-check none rsakeypair TP-self-signed-786894652 ! ! crypto pki certificate chain TP-self-signed-786894652 certificate self-signed 01 30820229 30820192 A0030201 02020101 300D0609 2A864886 F70D0101 05050030 30312E30 2C060355 04031325 494F532D 53656C66 2D536967 6E65642D 43657274 69666963 6174652D 37383638 39343635 32301E17 0D313330 36313930 34313632 365A170D 32303031 30313030 30303030 5A303031 2E302C06 03550403 1325494F 532D5365 6C662D53 69676E65 642D4365 72746966 69636174 652D3738 36383934 36353230 819F300D 06092A86 4886F70D 01010105 0003818D 00308189 02818100 CF2F3340 71C71575 C714AEDF F8CCB656 D87B8ECF 1B20F206 13A809DF 6DE1EA88 2E54BDA8 BE230D2D 77579C2C 7F49F308 02BD9150 47B1C94C EF4E0154 2E814F9B 1F373605 284028F8 71379335 92519FD4 1C9A7132 EFA535D7 235BF9F3 2E38FF76 AAF02971 9699F750 F633F337 342DE750 38EE7450 042EBC95 04A3E3DB 6B34B045 02030100 01A35330 51300F06 03551D13 0101FF04 05300301 01FF301F 0603551D 23041830 16801443 6C89AEF4 9B816C9E 8661491E 58D36F65 05900630 1D060355 1D0E0416 0414436C 89AEF49B 816C9E86 61491E58 D36F6505 9006300D 06092A86 4886F70D 01010505 00038181 0003AE46 358B10C9 2CC653DD 215D3809 DA92061F 0859E7EB 32B8E02A 32CADE7C DC7736F3 D961CC04 F78D6568 4C70FD6A 977DDD98 AEDC18D1 30642BBD 8D8400CB 577A3955 00190165 69AC390D 82E005A5 FA7E6A27 FA6A5D4B A8368F7C AFAA883A 923A530F 38377558 3D18E016 E6EC7AC1 514B10EB B64313DB 70410A3B 4F2D067A C5 --More--   quit voice-card 0 dsp services dspfarm ! ! ! voice service voip fax protocol t38 version 0 ls-redundancy 0 hs-redundancy 0 fallback none ! ! ! ! ! license udi pid CISCO2951/K9 sn FCZ172560DX hw-module pvdm 0/0 ! ! ! username admin password 0 cucM@2013 ! redundancy ! ! controller E1 0/0/0 --More--   pri-group timeslots 1-31 service mgcp description AMD-MOC-E1-2388XXXX ! controller E1 0/0/1 pri-group timeslots 1-31 service mgcp description FHH-MOC-E1-2388XXXX ! controller E1 0/0/2 description AMD-MOC-E1-2388XXXX ! controller E1 0/0/3 description TEC-MOC-E1-1866555 ! controller E1 0/1/0 pri-group timeslots 1-31 service mgcp description AMD-MOC-E1 2385[6-9]XXX ! controller E1 0/1/1 ! controller E1 0/1/2 ! controller E1 0/1/3 ! ip ssh version 2 --More--  ! ! ! ! interface Embedded-Service-Engine0/0 no ip address shutdown ! interface GigabitEthernet0/0 description $ETH-LAN$$ETH-SW-LAUNCH$$INTF-INFO-GE 0/0$ ip address 10.26.12.106 255.255.255.0 duplex auto speed auto ! interface GigabitEthernet0/1 no ip address shutdown duplex auto speed auto ! interface GigabitEthernet0/2 no ip address shutdown duplex auto --More--   speed auto ! interface Serial0/0/0:15 no ip address encapsulation hdlc isdn switch-type primary-net5 isdn incoming-voice voice no cdp enable ! interface Serial0/0/1:15 no ip address encapsulation hdlc isdn switch-type primary-net5 isdn incoming-voice voice no cdp enable ! interface Serial0/1/0:15 no ip address encapsulation hdlc no logging event link-status isdn switch-type primary-net5 isdn incoming-voice voice isdn bind-l3 ccm-manager no cdp enable --More--  ! ip forward-protocol nd ! no ip http server ip http access-class 23 ip http authentication local no ip http secure-server ip http timeout-policy idle 60 life 86400 requests 10000 ! ip route 0.0.0.0 0.0.0.0 10.26.12.1 ! ! nls resp-timeout 1 cpd cr-id 1 ! snmp-server engineID local 1234000000 snmp-server group KNPCCUOM v3 auth snmp-server contact -SHU-Exchange Room snmp-server enable traps snmp authentication linkdown linkup coldstart warmstart snmp-server enable traps envmon snmp-server enable traps config snmp-server enable traps syslog snmp-server host 10.26.12.203 version 3 auth KNPCCUOM ! --More--  control-plane ! ! voice-port 0/1/0:15 ! voice-port 0/0/0:15 ! voice-port 0/0/1:15 ! ccm-manager redundant-host 10.26.12.102 ccm-manager mgcp ccm-manager music-on-hold ! mgcp mgcp call-agent 10.26.12.101 2427 service-type mgcp version 0.1 mgcp bind control source-interface GigabitEthernet0/0 mgcp bind media source-interface GigabitEthernet0/0 ! mgcp profile default ! ! ! ! ! --More--  gatekeeper shutdown ! ! telephony-service max-conferences 8 gain -6 transfer-system full-consult ! ! banner exec ^C % Password expiration warning. ----------------------------------------------------------------------- Cisco Configuration Professional (Cisco CP) is installed on this device and it provides the default username "cisco" for one-time use. If you have already used the username "cisco" to login to the router and your IOS image supports the "one-time" user option, then this username has already expired. You will not be able to login to the router with this username after you exit this session. It is strongly suggested that you create a new username with a privilege level of 15 using the following command. username privilege 15 secret 0 --More--   Replace and with the username and password you want to use. ----------------------------------------------------------------------- ^C banner login ^C ----------------------------------------------------------------------- Cisco Configuration Professional (Cisco CP) is installed on this device. This feature requires the one-time use of the username "cisco" with the password "cisco". These default credentials have a privilege level of 15. YOU MUST USE CISCO CP or the CISCO IOS CLI TO CHANGE THESE PUBLICLY-KNOWN CREDENTIALS Here are the Cisco IOS commands. username privilege 15 secret 0 no username cisco Replace and with the username and password you want to use. IF YOU DO NOT CHANGE THE PUBLICLY-KNOWN CREDENTIALS, YOU WILL NOT BE ABLE --More--  TO LOG INTO THE DEVICE AGAIN AFTER YOU HAVE LOGGED OFF. For more information about Cisco CP please follow the instructions in the QUICK START GUIDE for your router or go to http://www.cisco.com/go/ciscocp ----------------------------------------------------------------------- ^C ! line con 0 password cucM%2012 login line aux 0 line 2 no activation-character no exec transport preferred none transport input all transport output pad telnet rlogin lapb-ta mop udptn v120 ssh stopbits 1 line vty 0 4 access-class 23 in privilege level 15 password cucM%2012 logging synchronous login local --More--   transport input telnet ssh line vty 5 15 access-class 23 in privilege level 15 login local transport input telnet ssh ! scheduler allocate 20000 1000 end HOB-2951-01#                  HOB-2951-01# HOB-2951-01# HOB-2951-01# HOB-2951-01# HOB-2951-01# HOB-2951-01# HOB-2951-01# HOB-2951-01# HOB-2951-01# HOB-2951-01# HOB-2951-01# HOB-2951-01#sh ver HOB-2951-01#sh version Cisco IOS Software, C2951 Software (C2951-UNIVERSALK9-M), Version 15.1(4)M5, RELEASE SOFTWARE (fc1) Technical Support: http://www.cisco.com/techsupport Copyright (c) 1986-2012 by Cisco Systems, Inc. Compiled Tue 04-Sep-12 16:50 by prod_rel_team ROM: System Bootstrap, Version 15.0(1r)M16, RELEASE SOFTWARE (fc1) HOB-2951-01 uptime is 45 weeks, 58 minutes System returned to ROM by power-on System restarted at 13:13:14 GMT Sat Feb 8 2014 System image file is "flash0:c2951-universalk9-mz.SPA.151-4.M5.bin" Last reload type: Normal Reload This product contains cryptographic features and is subject to United States and local country laws governing import, export, transfer and use. Delivery of Cisco cryptographic products does not imply third-party authority to import, export, distribute or use encryption. Importers, exporters, distributors and users are responsible for compliance with U.S. and local country laws. By using this product you agree to comply with applicable laws and regulations. If you are unable to comply with U.S. and local laws, return this product immediately. A summary of U.S. laws governing Cisco cryptographic products may be found at: http://www.cisco.com/wwl/export/crypto/tool/stqrg.html If you require further assistance please contact us by sending email to export@cisco.com. Cisco CISCO2951/K9 (revision 1.1) with 481280K/43008K bytes of memory. Processor board ID FCZ172560DX 3 Gigabit Ethernet interfaces 93 Serial interfaces 1 terminal line 8 Channelized E1/PRI ports DRAM configuration is 72 bits wide with parity enabled. 255K bytes of non-volatile configuration memory. 250880K bytes of ATA System CompactFlash 0 (Read/Write) License Info: License UDI: ------------------------------------------------- Device# PID SN -------------------------------------------------