On RV160 HUBGw Site-B Router
===========================




------------------------------
S2S Tunnel-2 to Site-C router
----------------------------------



Step-1: On RV160 Router, create the ipsec-algorithm-profile as below:

- This Ipsec-Profile, should be the same as used on both Site-A and Site-C routers

Name: IKEv1_Profile1
Version: IKEv1
Phase-1: AES128-SHA1-GROUP2; Lifetime: 28800sec
Phase-2: ESP; AES256-SHA256; pfs=no; lifetime:3600sec

- apply and do a permanent save too


Step-2: Configure the S2S tunnel-2 to SiteC router as below:


* In Basic Settings Tab:

Enable: Yes(enable checkbox)

Connection Name: toSiteC

IPSec Profile: IKEv1-Profile1

Interface: WAN1

Remote Endpoint: dynamic-IP


IKE Authentication Method:

Pre-Shared-Key: Test$123456789


Local Group Setup:

Local ID Type: Local FQDN

Local Identifier: hubgw.test.local

Local IP Type: ANY



Remote Group Setup:

Remote ID Type: Remote FQDN

Remote Identifier: spoke2gw.test.local

Remote IP Type: Subnet

IP Address: 192.168.2.0
Subnet Mask: 255.255.255.0


* In Advanced Settings Tab:
-------------------------

Aggressive Mode: Enable/checked

Compress: Disable/Unchecked

Netbios Broadcast: Disable/Unchecked

Keepalive: Disabled/Unchecked

DPD Enable: Yes (Checked/Enable)
 - Delay Time:10s
 - Detection Timeout: 30s
 - Delay Action: clear