=~=~=~=~=~=~=~=~=~=~=~= PuTTY log 2016.11.22 22:01:30 =~=~=~=~=~=~=~=~=~=~=~=
sh
VG-POC#show voic
VG-POC#show voice por
VG-POC#show voice port 0/1/1

Foreign Exchange Office 0/1/1 Slot is 0, Sub-unit is 1, Port is 1
 Type of VoicePort is FXO
 Operation State is DOWN
 Administrative State is UP
 The Last Interface Down Failure Cause is Administrative Shutdown
 Description is not set
 Noise Regeneration is enabled
 Non Linear Processing is enabled
 Non Linear Mute is disabled
 Non Linear Threshold is -21 dB
 Music On Hold Threshold is Set to -38 dBm
 In Gain is Set to 0 dB
 Out Attenuation is Set to 3 dB
 Echo Cancellation is enabled
 Echo Cancellation NLP mute is disabled
 Echo Cancellation NLP threshold is -21 dB
 Echo Cancel Coverage is set to 128 ms
 Echo Cancel worst case ERL is set to 6 dB
 Playout-delay Mode is set to adaptive
 Playout-delay Nominal is set to 60 ms
 Playout-delay Maximum is set to 1000 ms
 Playout-delay Minimum mode is set to default, value 40 ms 
 Playout-delay Fax is set to 300 ms
 Connection Mode is plar opx
 Connection Number is 5506
 Initial Time Out is set to 5 s
 Interdigit Time Out is set to 3 s
 Call Disconnect Time Out is set to 3 s
 Power Denial Disconnect Time Out is set to 1000 ms
 Ringing Time Out is set to 5 s
 Wait Release Time Out is set to 1 s
 Companding Type is u-law
 Region Tone is set for US

 Analog Info Follows:
 Currently processing none
 Maintenance Mode Set to None (not in mtc mode)
 Number of signaling protocol errors are 0
 Impedance is set to 600r Ohm
 Station name None, Station number None

 Caller ID Info Follows:
 --More--          Standard BELLCORE
 Input attenuation is set to 0.0 dB
 Caller ID is received after 1 ring(s)
 Translation profile (Incoming): 
 Translation profile (Outgoing): 
 lpcor (Incoming): 
 lpcor (Outgoing): 

 Voice card specific Info Follows:
 Signal Type is groundStart 
 Battery-Reversal is disabled
 Number Of Rings is set to 1
 Supervisory Disconnect is dualtone mid-call
 Answer Supervision is inactive
 Hook Status is On Hook
 Ring Detect Status is inactive
 Ring Ground Status is inactive
 Tip Ground Status is inactive
 Dial Out Type is dtmf
 Digit Duration Timing is set to 100 ms
 InterDigit Duration Timing is set to 100 ms
 Pulse Rate Timing is set to 10 pulses/second
 InterDigit Pulse Duration Timing is set to 750 ms
 Percent Break of Pulse is 60 percent
 GuardOut timer is 1000 ms
 Minimum ring duration timer is 125 ms
 Hookflash-in Timing is set to 600 ms
 Hookflash-out Timing is set to 50 ms
 Supervisory Disconnect Timing (loopStart only) is set to 350 ms
 OPX Ring Wait Timing is set to 6000 ms
 Secondary dialtone is disabled
VG-POC#