VG-JED1-SIP# VG-JED1-SIP# VG-JED1-SIP#sh run br Building configuration... Current configuration : 12071 bytes ! ! Last configuration change at 17:42:43 AST Thu Aug 3 2017 ! NVRAM config last updated at 17:42:43 AST Thu Aug 3 2017 ! version 15.4 service timestamps debug datetime msec service timestamps log datetime msec no service password-encryption ! hostname VG-JED1-SIP ! boot-start-marker boot-end-marker ! ! logging buffered 51200 warnings ! no aaa new-model clock timezone AST 3 0 ! ! ! ! ! ! ! ! ! ! ! ! ! ! no ip domain lookup ip domain name yourdomain.com ip cef no ipv6 cef multilink bundle-name authenticated ! ! ! ! ! ! cts logging verbose ! crypto pki trustpoint TP-self-signed-2896387755 enrollment selfsigned subject-name cn=IOS-Self-Signed-Certificate-2896387755 revocation-check none rsakeypair TP-self-signed-2896387755 ! ! crypto pki certificate chain TP-self-signed-2896387755 certificate self-signed 01 voice-card 0 dspfarm dsp services dspfarm ! ! ! voice service voip allow-connections h323 to h323 allow-connections h323 to sip allow-connections sip to h323 allow-connections sip to sip fax protocol t38 version 0 ls-redundancy 0 hs-redundancy 0 fallback none sip registrar server early-offer forced ! voice class codec 1 codec preference 1 g711alaw codec preference 2 g711ulaw codec preference 3 g729br8 ! ! ! ! ! ! voice translation-rule 1 rule 1 /^86../ /2168900/ rule 2 /^87../ /2168900/ rule 3 /^88../ /2168900/ rule 4 /^89\(..\)/ /21689\1/ rule 5 /^85../ /2168900/ ! voice translation-rule 2 rule 1 /^2168/ /8/ rule 2 /^22168/ /8/ rule 3 /^122168/ /8/ rule 4 /^0122168/ /8/ ! voice translation-rule 3 rule 1 /^5/ /05/ rule 2 /^1/ /01/ ! voice translation-rule 4 rule 1 /^9/ // ! ! voice translation-profile SIP-Incoming-and-Redial translate calling 3 translate called 2 ! voice translation-profile SIPOUT-and-NONDID translate calling 1 translate called 4 ! ! ! license udi pid CISCO2911/K9 sn FGL2022114V hw-module pvdm 0/0 ! ! ! username admin privilege 15 password 0 cisco@123 username ggi privilege 15 secret 5 $1$mbQL$1W8oYlWUxs9koQf0VAAwk. ! redundancy ! ! ! ! ! ! interface Embedded-Service-Engine0/0 no ip address shutdown ! interface GigabitEthernet0/0 description $ETH-LAN$$ETH-SW-LAUNCH$$INTF-INFO-GE 0/0$ no ip address duplex auto speed auto ! interface GigabitEthernet0/0.1100 description **Link to Interface Vlan 1100** encapsulation dot1Q 1100 ip address 10.10.110.120 255.255.255.0 ! interface GigabitEthernet0/0.1121 description **Link to Interface Vlan 1121** encapsulation dot1Q 1121 ip address 10.12.1.10 255.255.255.0 ! interface GigabitEthernet0/1 description JEDDAH_JEDDAH SIP 5491 (SIP CIRCUIT) ip address 10.68.9.106 255.255.255.252 duplex auto speed auto ! interface GigabitEthernet0/2 no ip address shutdown duplex auto speed auto ! ip forward-protocol nd ! ip http server ip http access-class 23 ip http authentication local ip http secure-server ip http timeout-policy idle 60 life 86400 requests 10000 ! ip route 0.0.0.0 0.0.0.0 10.10.110.1 ip route 10.12.2.0 255.255.255.0 10.12.1.1 ip route 10.12.3.0 255.255.255.0 10.12.1.1 ip route 10.12.4.0 255.255.255.0 10.12.1.1 ip route 10.208.9.0 255.255.255.0 10.68.9.105 ! ! ! ! control-plane ! ! ! ! ! ! mgcp behavior rsip-range tgcp-only mgcp behavior comedia-role none mgcp behavior comedia-check-media-src disable mgcp behavior comedia-sdp-force disable ! mgcp profile default ! sccp local GigabitEthernet0/0.1100 sccp ccm 10.10.110.121 identifier 1 priority 1 version 7.0 sccp ccm 10.10.111.121 identifier 2 priority 2 version 7.0 sccp ! sccp ccm group 1 associate ccm 1 priority 1 associate ccm 2 priority 2 associate profile 3 register IOS-XCODE associate profile 2 register IOS-MTP associate profile 1 register IOS-CONF ! ! ! dspfarm profile 3 transcode codec g729abr8 codec g729ar8 codec g711alaw codec g711ulaw codec g729r8 codec g729br8 maximum sessions 3 associate application SCCP ! dspfarm profile 1 conference codec g729br8 codec g729r8 codec g729abr8 codec g729ar8 codec g711alaw codec g711ulaw maximum sessions 2 associate application SCCP ! dspfarm profile 2 mtp codec g711ulaw maximum sessions hardware 3 associate application SCCP ! dial-peer voice 1 voip description ** SIP INCOMING FROM STC & CM Primary Server** translation-profile incoming SIP-Incoming-and-Redial destination-pattern 8... session protocol sipv2 session target ipv4:10.10.111.121 incoming called-number 2168... voice-class codec 1 dtmf-relay sip-notify rtp-nte sip-kpml ! dial-peer voice 2 voip description ** SIP INCOMING FROM STC & CM Primary Server** translation-profile incoming SIP-Incoming-and-Redial destination-pattern 8... session protocol sipv2 session target ipv4:10.10.111.121 incoming called-number 22168... voice-class codec 1 dtmf-relay sip-notify rtp-nte sip-kpml ! dial-peer voice 3 voip description ** SIP INCOMING FROM STC & CM Primary Server** translation-profile incoming SIP-Incoming-and-Redial destination-pattern 8... session protocol sipv2 session target ipv4:10.10.111.121 incoming called-number 122168... voice-class codec 1 dtmf-relay sip-notify rtp-nte sip-kpml ! dial-peer voice 4 voip description ** SIP INCOMING FROM STC & CM Primary Server** translation-profile incoming SIP-Incoming-and-Redial destination-pattern 8... session protocol sipv2 session target ipv4:10.10.111.121 incoming called-number 0122168... voice-class codec 1 dtmf-relay sip-notify rtp-nte sip-kpml ! dial-peer voice 5 voip description ** SIP INCOMING FROM STC & CM Secondary Server** translation-profile incoming SIP-Incoming-and-Redial preference 1 destination-pattern 8... session protocol sipv2 session target ipv4:10.10.110.121 incoming called-number 2168... voice-class codec 1 dtmf-relay sip-notify rtp-nte sip-kpml ! dial-peer voice 6 voip description ** SIP INCOMING FROM STC & CM Secondary Server** translation-profile incoming SIP-Incoming-and-Redial preference 1 destination-pattern 8... session protocol sipv2 session target ipv4:10.10.110.121 incoming called-number 22168... voice-class codec 1 dtmf-relay sip-notify rtp-nte sip-kpml ! dial-peer voice 7 voip description ** SIP INCOMING FROM STC & CM Secondary Server** translation-profile incoming SIP-Incoming-and-Redial preference 1 destination-pattern 8... session protocol sipv2 session target ipv4:10.10.110.121 incoming called-number 122168... voice-class codec 1 dtmf-relay sip-notify rtp-nte sip-kpml ! dial-peer voice 8 voip description ** SIP INCOMING FROM STC & CM Secondary Server** translation-profile incoming SIP-Incoming-and-Redial preference 1 destination-pattern 8... session protocol sipv2 session target ipv4:10.10.110.121 incoming called-number 0122168...$ voice-class codec 1 dtmf-relay sip-notify rtp-nte sip-kpml ! dial-peer voice 9 voip description ** ROUTE TO STC SIP SERVER for Mobile** translation-profile outgoing SIPOUT-and-NONDID destination-pattern 905........$ session protocol sipv2 session target ipv4:10.208.9.69:5060 session transport udp voice-class codec 1 voice-class sip dtmf-relay force rtp-nte dtmf-relay sip-notify rtp-nte sip-kpml ! dial-peer voice 11 voip description ** ROUTE TO STC SIP SERVER for National** translation-profile outgoing SIPOUT-and-NONDID destination-pattern 90[12346789]........$ session protocol sipv2 session target ipv4:10.208.9.69:5060 session transport udp voice-class codec 1 voice-class sip dtmf-relay force rtp-nte dtmf-relay sip-notify rtp-nte sip-kpml ! dial-peer voice 12 voip description ** ROUTE TO STC SIP SERVER for Local** translation-profile outgoing SIPOUT-and-NONDID destination-pattern 9[264]......$ session protocol sipv2 session target ipv4:10.208.9.69:5060 session transport udp voice-class codec 1 voice-class sip dtmf-relay force rtp-nte dtmf-relay sip-notify rtp-nte sip-kpml ! dial-peer voice 13 voip description ** ROUTE TO STC SIP SERVER for TollFree** translation-profile outgoing SIPOUT-and-NONDID destination-pattern 9800.......$ session protocol sipv2 session target ipv4:10.208.9.69:5060 session transport udp voice-class codec 1 voice-class sip dtmf-relay force rtp-nte dtmf-relay sip-notify rtp-nte sip-kpml ! dial-peer voice 14 voip description ** ROUTE TO STC SIP SERVER for UniversalService** translation-profile outgoing SIPOUT-and-NONDID destination-pattern 99200.....$ session protocol sipv2 session target ipv4:10.208.9.69:5060 session transport udp voice-class codec 1 voice-class sip dtmf-relay force rtp-nte dtmf-relay sip-notify rtp-nte sip-kpml ! dial-peer voice 15 voip description ** ROUTE TO STC SIP SERVER for Services** translation-profile outgoing SIPOUT-and-NONDID destination-pattern 990.$ session protocol sipv2 session target ipv4:10.208.9.69:5060 session transport udp voice-class codec 1 voice-class sip dtmf-relay force rtp-nte dtmf-relay sip-notify rtp-nte sip-kpml ! dial-peer voice 16 voip description ** ROUTE TO STC SIP SERVER for Emergency** translation-profile outgoing SIPOUT-and-NONDID destination-pattern 999.$ session protocol sipv2 session target ipv4:10.208.9.69:5060 session transport udp voice-class codec 1 voice-class sip dtmf-relay force rtp-nte dtmf-relay sip-notify rtp-nte sip-kpml ! dial-peer voice 17 voip description ** ROUTE TO STC SIP SERVER for International** translation-profile outgoing SIPOUT-and-NONDID destination-pattern 900T session protocol sipv2 session target ipv4:10.208.9.69:5060 session transport udp voice-class codec 1 voice-class sip dtmf-relay force rtp-nte dtmf-relay sip-notify rtp-nte sip-kpml ! dial-peer voice 10 voip voice-class codec 1 ! ! ! ! gatekeeper shutdown ! ! banner exec ^C % Password expiration warning. ----------------------------------------------------------------------- Cisco Configuration Professional (Cisco CP) is installed on this device and it provides the default username "cisco" for one-time use. If you have already used the username "cisco" to login to the router and your IOS image supports the "one-time" user option, then this username has already expired. You will not be able to login to the router with this username after you exit this session. It is strongly suggested that you create a new username with a privilege level of 15 using the following command. username privilege 15 secret 0 Replace and with the username and password you want to use. ----------------------------------------------------------------------- ^C banner login ^C ----------------------------------------------------------------------- Cisco Configuration Professional (Cisco CP) is installed on this device. This feature requires the one-time use of the username "cisco" with the password "cisco". These default credentials have a privilege level of 15. YOU MUST USE CISCO CP or the CISCO IOS CLI TO CHANGE THESE PUBLICLY-KNOWN CREDENTIALS Here are the Cisco IOS commands. username privilege 15 secret 0 no username cisco Replace and with the username and password you want to use. IF YOU DO NOT CHANGE THE PUBLICLY-KNOWN CREDENTIALS, YOU WILL NOT BE ABLE TO LOG INTO THE DEVICE AGAIN AFTER YOU HAVE LOGGED OFF. For more information about Cisco CP please follow the instructions in the QUICK START GUIDE for your router or go to http://www.cisco.com/go/ciscocp ----------------------------------------------------------------------- ^C ! line con 0 exec-timeout 0 0 privilege level 15 password cisco@123 logging synchronous login line aux 0 line 2 no activation-character no exec transport preferred none transport output pad telnet rlogin lapb-ta mop udptn v120 ssh stopbits 1 line vty 0 4 access-class 23 in exec-timeout 0 0 privilege level 15 password cisco@123 logging synchronous login transport input telnet ssh line vty 5 15 access-class 23 in exec-timeout 0 0 privilege level 15 password cisco@123 logging synchronous login transport input telnet ssh ! scheduler allocate 20000 1000 ntp master 1 ! end VG-JED1-SIP#