rommon 3 > 

rommon 3 > 

rommon 3 > dev

Devices in device table:

        id  name

    flash:  flash                      

rommon 4 > dir flash:

         File size           Checksum   File name

  10314672 bytes (0x9d63b0)   0x1545    c2600-is-mz.122-32.bin

    260776 bytes (0x3faa8)    0xe089    crashinfo_19930301-011002

rommon 5 > boot flash:c2600-is-mz.122-32.bin

program load complete, entry point: 0x80008000, size: 0x9d6294

Self decompressing the image : ############################################################################################################################################################################################### [OK]


Smart Init is enabled

smart init is sizing iomem

  ID            MEMORY_REQ                 TYPE

000091          0X00092280 C2600 single Ethernet

000064          0X00016500 Two port Voice PM

                0X000F3BB0 public buffer pools

                0X00211000 public particle pools

TOTAL:          0X003AD330


If any of the above Memory Requirements are 

"UNKNOWN", you may be using an unsupported

configuration or there is a software problem and

system operation may be compromised.

Rounded IOMEM up to: 4Mb.

Using 8 percent iomem. [4Mb/48Mb]
               Restricted Rights Legend

Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.

           cisco Systems, Inc.
           170 West Tasman Drive
           San Jose, California 95134-1706



Cisco Internetwork Operating System Software 
IOS (tm) C2600 Software (C2600-IS-M), Version 12.2(32), RELEASE SOFTWARE (fc1)
Copyright (c) 1986-2005 by cisco Systems, Inc.
Compiled Fri 02-Dec-05 22:16 by 
Image text-base: 0x8000808C, data-base: 0x8111C164

cisco 2610 (MPC860) processor (revision 0x00) with 45056K/4096K bytes of memory.
Processor board ID JAD06220K3J (4061845557)
M860 processor: part number 0, mask 49
Bridging software.
X.25 software, Version 3.0.0.
1 Ethernet/IEEE 802.3 interface(s)
2 Serial network interface(s)
2 Voice FXO interface(s)
32K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read/Write)
 


Press RETURN to get started!


00:00:11: %LINK-3-UPDOWN: Interface Ethernet0/0, changed state to up
00:00:11: %LINK-3-UPDOWN: Interface Serial0/0, changed state to down
00:00:11: %LINK-3-UPDOWN: Interface Serial0/1, changed state to down
*Mar  1 00:00:12.327: %LINEPROTO-5-UPDOWN: Line protocol on Interface Ethernet0/0, changed state to up
*Mar  1 00:00:12.327: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0, changed state to down
*Mar  1 00:00:12.327: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/1, changed state to down
*Mar  1 00:00:12.772: %SYS-5-CONFIG_I: Configured from memory by console
*Mar  1 00:00:14.227: %LINK-5-CHANGED: Interface Serial0/0, changed state to administratively down
*Mar  1 00:00:14.231: %LINK-5-CHANGED: Interface Serial0/1, changed state to administratively down
*Mar  1 00:00:15.585: %SYS-5-RESTART: System restarted --
Cisco Internetwork Operating System Software 
IOS (tm) C2600 Software (C2600-IS-M), Version 12.2(32), RELEASE SOFTWARE (fc1)
Copyright (c) 1986-2005 by cisco Systems, Inc.
Compiled Fri 02-Dec-05 22:16 by 
*Mar  1 00:00:15.589: %SNMP-5-COLDSTART: SNMP agent on host GW is undergoing a cold start
*Mar  1 00:00:16.470: %LINK-3-UPDOWN: Interface Foreign Exchange Office 1/0/1, changed state to up
*Mar  1 00:00:16.474: %LINK-3-UPDOWN: Interface Foreign Exchange Office 1/0/0, changed state to up
GW>
GW>
GW>
GW>