WW-Router>en Password: WW-Router# 1w2d: %SYS-2-MALLOCFAIL: Memory allocation of 928 bytes failed from 0x4036E1B0, alignment 0 Pool: Processor Free: 257336 Cause: Memory fragmentation Alternate Pool: None Free: 0 Cause: No Alternate pool -Process= "Pool Manager", ipl= 0, pid= 5, -Traceback= 0x40EE6418 0x4008182C 0x 4009A5D0 0x4211B5B0 0x4036E1B8 0x400BAAA0 0x400BAC5C 0x41C636AC 0x41C63690 1w2d: %SYS-2-CHUNKEXPANDFAIL: Could not expand chunk pool for ADJ: request r. No memory available -Process= "Chunk Manager", ipl= 4, pid= 1, -Traceback= 0x40EE 6418 0x400B3F3C 0x41C636AC 0x41C63690 1w2d: %SYS-2-CHUNKEXPANDFAIL: Could not expand chunk pool for ADJ: request r. No memory available -Process= "Chunk Manager", ipl= 4, pid= 1, -Traceback= 0x40EE 6418 0x400B3F3C 0x41C636AC 0x41C63690 1w2d: %SYS-2-MALLOCFAIL: Memory allocation of 928 bytes failed from 0x4036E1B0, alignment 0 Pool: Processor Free: 257336 Cause: Memory fragmentation Alternate Pool: None Free: 0 Cause: No Alternate pool -Process= "Pool Manager", ipl= 0, pid= 5, -Traceback= 0x40EE6418 0x4008182C 0x 4009A5D0 0x4211B5B0 0x4036E1B8 0x400BAAA0 0x400BAC5C 0x41C636AC 0x41C63690 1w2d: %SYS-2-MALLOCFAIL: Memory allocation of 928 bytes failed from 0x4036E1B0, alignment 0 Pool: Processor Free: 257336 Cause: Memory fragmentation Alternate Pool: None Free: 0 Cause: No Alternate pool -Process= "Pool Manager", ipl= 0, pid= 5, -Traceback= 0x40EE6418 0x4008182C 0x 4009A5D0 0x4211B5B0 0x4036E1B8 0x400BAAA0 0x400BAC5C 0x41C636AC 0x41C63690 1w2d: %SYS-2-CHUNKEXPANDFAIL: Could not expand chunk pool for ADJ: request r. No memory available -Process= "Chunk Manager", ipl= 4, pid= 1, -Traceback= 0x40EE 6418 0x400B3F3C 0x41C636AC 0x41C63690 1w2d: %SYS-2-CHUNKEXPANDFAIL: Could not expand chunk pool for ADJ: request r. No memory available -Process= "Chunk Manager", ipl= 4, pid= 1, -Traceback= 0x40EE 6418 0x400B3F3C 0x41C636AC 0x41C63690 1w2d: %SYS-2-MALLOCFAIL: Memory allocation of 928 bytes failed from 0x4036E1B0, alignment 0 Pool: Processor Free: 257336 Cause: Memory fragmentation Alternate Pool: None Free: 0 Cause: No Alternate pool -Process= "Pool Manager", ipl= 0, pid= 5, -Traceback= 0x40EE6418 0x4008182C 0x 4009A5D0 0x4211B5B0 0x4036E1B8 0x400BAAA0 0x400BAC5C 0x41C636AC 0x41C63690 1w2d: %SYS-2-CHUNKEXPANDFAIL: Could not expand chunk pool for ADJ: request r. No memory available -Process= "Chunk Manager", ipl= 4, pid= 1, -Traceback= 0x40EE 6418 0x400B3F3C 0x41C636AC 0x41C63690 1w2d: %SYS-2-CHUNKEXPANDFAIL: Could not expand chunk pool for ADJ: request r. No memory available -Process= "Chunk Manager", ipl= 4, pid= 1, -Traceback= 0x40EE 6418 0x400B3F3C 0x41C636AC 0x41C63690 1w2d: %SYS-2-MALLOCFAIL: Memory allocation of 928 bytes failed from 0x4036E1B0, alignment 0 Pool: Processor Free: 257336 Cause: Memory fragmentation Alternate Pool: None Free: 0 Cause: No Alternate pool -Process= "Pool Manager", ipl= 0, pid= 5, -Traceback= 0x40EE6418 0x4008182C 0x 4009A5D0 0x4211B5B0 0x4036E1B8 0x400BAAA0 0x400BAC5C 0x41C636AC 0x41C63690 1w2d: %SYS-2-MALLOCFAIL: Memory allocation of 928 bytes failed from 0x4036E1B0, alignment 0 Pool: Processor Free: 257336 Cause: Memory fragmentation Alternate Pool: None Free: 0 Cause: No Alternate pool -Process= "Pool Manager", ipl= 0, pid= 5, -Traceback= 0x40EE6418 0x4008182C 0x 4009A5D0 0x4211B5B0 0x4036E1B8 0x400BAAA0 0x400BAC5C 0x41C636AC 0x41C63690 1w2d: %SYS-2-CHUNKEXPANDFAIL: Could not expand chunk pool for ADJ: request r. No memory available -Process= "Chunk Manager", ipl= 4, pid= 1, -Traceback= 0x40EE 6418 0x400B3F3C 0x41C636AC 0x41C63690 1w2d: %SYS-2-MALLOCFAIL: Memory allocation of 928 bytes failed from 0x4036E1B0, alignment 0 Pool: Processor Free: 257336 Cause: Memory fragmentation Alternate Pool: None Free: 0 Cause: No Alternate pool -Process= "Pool Manager", ipl= 0, pid= 5, -Traceback= 0x40EE6418 0x4008182C 0x 4009A5D0 0x4211B5B0 0x4036E1B8 0x400BAAA0 0x400BAC5C 0x41C636AC 0x41C63690 1w2d: %SYS-2-CHUNKEXPANDFAIL: Could not expand chunk pool for ADJ: request r. No memory available -Process= "Chunk Manager", ipl= 4, pid= 1, -Traceback= 0x40EE 6418 0x400B3F3C 0x41C636AC 0x41C63690 System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1) Technical Support: http://www.cisco.com/techsupport Copyright (c) 2006 by cisco Systems, Inc. Initializing memory for ECC . c2811 platform with 262144 Kbytes of main memory Main memory is configured to 64 bit mode with ECC enabled Readonly ROMMON initialized open: file "c2800nm-adventerprisek9-mz.124-9.T7.bin" not found open(): Open Error = -1 loadprog: error - on file open boot: cannot load "flash:c2800nm-adventerprisek9-mz.124-9.T7.bin" c2811 platform with 262144 Kbytes of main memory Main memory is configured to 64 bit mode with ECC enabled Readonly ROMMON initialized program load complete, entry point: 0x8000f000, size: 0x1d69934 Self decompressing the image : ################################################# ################################################################################ ######################################### [OK] Smart Init is enabled smart init is sizing iomem ID MEMORY_REQ TYPE 0003E7 0X00474800 C2811 Mainboard 000056 0X000C2800 4-port FE Switch HWIC 0X000021B8 Onboard USB 0X002C29F0 public buffer pools 0X00211000 public particle pools TOTAL: 0X00A0CBA8 If any of the above Memory Requirements are "UNKNOWN", you may be using an unsupported configuration or there is a software problem and system operation may be compromised. Rounded IOMEM up to: 12Mb. Using 4 percent iomem. [12Mb/256Mb] Restricted Rights Legend Use, duplication, or disclosure by the Government is subject to restrictions as set forth in subparagraph (c) of the Commercial Computer Software - Restricted Rights clause at FAR sec. 52.227-19 and subparagraph (c) (1) (ii) of the Rights in Technical Data and Computer Software clause at DFARS sec. 252.227-7013. cisco Systems, Inc. 170 West Tasman Drive San Jose, California 95134-1706 Cisco IOS Software, 2800 Software (C2800NM-IPBASEK9-M), Version 12.4(22)T4, RELE ASE SOFTWARE (fc2) Technical Support: http://www.cisco.com/techsupport Copyright (c) 1986-2009 by Cisco Systems, Inc. Compiled Mon 14-Dec-09 19:16 by prod_rel_team This product contains cryptographic features and is subject to United States and local country laws governing import, export, transfer and use. Delivery of Cisco cryptographic products does not imply third-party authority to import, export, distribute or use encryption. Importers, exporters, distributors and users are responsible for compliance with U.S. and local country laws. By using this product you agree to comply with applicable laws and regulations. If you are unable to comply with U.S. and local laws, return this product immediately. A summary of U.S. laws governing Cisco cryptographic products may be found at: http://www.cisco.com/wwl/export/crypto/tool/stqrg.html If you require further assistance please contact us by sending email to export@cisco.com. Cisco 2811 (revision 49.46) with 249856K/12288K bytes of memory. Processor board ID FCZ1238715H 6 FastEthernet interfaces DRAM configuration is 64 bits wide with parity enabled. 239K bytes of non-volatile configuration memory. 62720K bytes of ATA CompactFlash (Read/Write) Press RETURN to get started! *Aug 11 08:23:18.691: %ESWMRVL_FLTMG-5-NOTICE: Notice: FPGA Rev 0x71 *Aug 11 08:23:24.475: %LINK-3-UPDOWN: Interface FastEthernet0/0, changed state t o up *Aug 11 08:23:24.475: %LINK-3-UPDOWN: Interface FastEthernet0/1, changed state t o up *Aug 11 08:23:25.391: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan1, cha nged state to down *Aug 11 08:23:25.475: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthern et0/0, changed state to up *Aug 11 08:23:25.475: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthern et0/1, changed state to down 00:00:49: %LINEPROTO-5-UPDOWN: Line protocol on Interface Tunnel6, changed state to down 00:00:49: %LINEPROTO-5-UPDOWN: Line protocol on Interface Tunnel7, changed state to down 00:00:49: %SYS-5-CONFIG_I: Configured from memory by console 00:00:49: %SYS-5-RESTART: System restarted -- Cisco IOS Software, 2800 Software (C2800NM-IPBASEK9-M), Version 12.4(22)T4, RELE ASE SOFTWARE (fc2) Technical Support: http://www.cisco.com/techs* West Wharf Rouupport Copyright (c) 1986-2009 by Cisco Systems, Inc. Compiled Mon 14-Dec-09 19:16 by prod_rel_team 00:00:49: %SNMP-5-COLDSTART: SNMP agent on host WW-Router is undergoing a cold s tart 00:00:50: %SYS-6-LOGGINGHOST_STARTSTOP: Logging to host 172.16.0.150 port 514 st arted - CLI initiated 00:00:50: %DTP-5-TRUNKPORTON: Port Fa0/0/0 has become dot1q trunk 00:00:51: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan1, changed state t o up 00:00:51: %LINK-3-UPDOWN: Interface FastEthernet0/0/3, changed state to up 00:00:51: %LINK-3-UPDOWN: Interface FastEthernet0/0/2, changed state to up 00:00:51: %LINK-3-UPDOWN: Interface FastEthernet0/0/1, changed state to up 00:00:51: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1, chang ed state to up 00:00:52: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0/3, cha nged state to down 00:00:52: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0/2, cha nged state to up 00:00:52: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0/1, cha nged state to up 00:00:52: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0/0, cha nged state to upter - Restricted Access * User Access Verification