Current configuration : 5677 bytes
!
! Last configuration change at 14:54:34 UTC Wed Jun 26 2024 by cisco
!
version 15.7
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname dsl
!
boot-start-marker
boot-end-marker
!
!
enable secret 5 [removed]
!
no aaa new-model
!
!
!
!
!
!
!
!
!
ip dhcp excluded-address 192.168.1.200 192.168.1.254
ip dhcp excluded-address 192.168.1.1
!
ip dhcp pool dhcpp
 network 192.168.1.0 255.255.255.0
 default-router 192.168.1.201
 dns-server 192.168.1.201
!
!
!
ip name-server 8.8.8.8
ip cef
no ipv6 cef
multilink bundle-name authenticated
!
vpdn enable
!
vpdn-group pppoe
!
!
!
!
!
!
crypto pki trustpoint TP-self-signed-1506410671
 enrollment selfsigned
 subject-name cn=IOS-Self-Signed-Certificate-1506410671
 revocation-check none
 rsakeypair TP-self-signed-1506410671
!
!
crypto pki certificate chain TP-self-signed-1506410671
 certificate self-signed 01
  [removed]
        quit
voice-card 0
!
!
!
!
voice hunt-group 1 parallel
 list 11,0
 timeout 15
 pilot 10
!
!
!
!
!
!
vxml logging-tag
license udi pid CISCO2901/K9 sn [removed]
hw-module pvdm 0/0
!
hw-module pvdm 0/1
!
!
!
username cisco privilege 15 secret 5 [removed]
!
redundancy
!
!
controller VDSL 0/3/0
 firmware filename flash0:dsl.bin
 modem ukfeature
!
!
!
!
!
interface Loopback0
 ip address 10.27.87.1 255.255.255.0
 ip nat outside
 ip virtual-reassembly in
!
interface Embedded-Service-Engine0/0
 no ip address
 shutdown
!
interface GigabitEthernet0/0
 no ip address
 shutdown
 duplex auto
 speed auto
!
interface GigabitEthernet0/1
 no ip address
 ip nat inside
 ip virtual-reassembly in
 duplex auto
 speed auto
!
interface ATM0/3/0
 no ip address
 shutdown
 no atm ilmi-keepalive
!
interface Ethernet0/3/0
 no ip address
 no ip redirects
 no ip unreachables
 no ip proxy-arp
 ip tcp adjust-mss 1452
 load-interval 30
!
interface Ethernet0/3/0.101
 encapsulation dot1Q 101
 pppoe enable group global
 pppoe-client dial-pool-number 1
!
interface GigabitEthernet0/0/0
 switchport access vlan 10
 switchport mode access
 no ip address
!
interface GigabitEthernet0/0/1
 switchport access vlan 10
 switchport mode access
 no ip address
!
interface GigabitEthernet0/0/2
 switchport access vlan 10
 switchport mode access
 no ip address
!
interface GigabitEthernet0/0/3
 switchport access vlan 10
 switchport mode access
 no ip address
!
interface Vlan1
 no ip address
!
interface Vlan10
 ip address 192.168.1.201 255.255.255.0
 ip nat inside
 ip virtual-reassembly in
!
interface Dialer1
 mtu 1492
 ip address negotiated
 ip nat outside
 ip virtual-reassembly in
 encapsulation ppp
 dialer pool 1
 no cdp enable
 ppp chap hostname [removed]
 ppp chap password 0 [removed]
 ppp pap sent-username [removed] password 0 [removed]
!
ip forward-protocol nd
!
ip http server
ip http secure-server
!
ip dns server
ip dns spoofing 192.168.1.201
ip nat inside source list 1 interface Dialer1 overload
ip route 0.0.0.0 0.0.0.0 Dialer1
ip ssh time-out 90
ip ssh version 2
!
ip access-list standard ALLOW-SSH
 permit 192.168.1.0 0.0.0.255
!
logging host 192.168.1.200
!
!
access-list 1 permit 192.168.1.201
access-list 1 permit any
!
control-plane
!
!
voice-port 0/1/0
!
voice-port 0/1/1
!
voice-port 0/1/2
!
voice-port 0/1/3
!
voice-port 0/2/0
 connection plar 10
!
voice-port 0/2/1
!
voice-port 0/2/2
!
voice-port 0/2/3
 !
 !
 !
 !
!
mgcp behavior rsip-range tgcp-only
mgcp behavior comedia-role none
mgcp behavior comedia-check-media-src disable
mgcp behavior comedia-sdp-force disable
!
mgcp profile default
!
!
!
!
dial-peer voice 1 pots
 destination-pattern 10
 port 0/1/0
!
dial-peer voice 2 pots
 destination-pattern 11
 port 0/1/1
!
dial-peer voice 3 pots
 destination-pattern 12
 port 0/1/2
!
dial-peer voice 4 pots
 destination-pattern 13
 port 0/1/3
!
dial-peer voice 10 pots
 destination-pattern 9T
 port 0/2/0
!
dial-peer voice 101 voip
!
!
!
!
gatekeeper
 shutdown
!
!
line con 0
line aux 0
line 2
 no activation-character
 no exec
 transport preferred none
 transport output pad telnet rlogin lapb-ta mop udptn v120 ssh
 stopbits 1
line vty 0
 access-class ALLOW-SSH in
 login local
 transport input none
line vty 1 4
 access-class ALLOW-SSH in
 login local
 transport input ssh
line vty 5 10
 login
 transport input ssh
line 2
 no activation-character
 no exec
 transport preferred none
 transport output pad telnet rlogin lapb-ta mop udptn v120 ssh
 stopbits 1
line vty 0
 access-class ALLOW-SSH in
 login local
 transport input none
line vty 1 4
 access-class ALLOW-SSH in
 login local
 transport input ssh
line vty 5 10
 login
 transport input ssh
!
scheduler allocate 20000 1000
ntp server pool.ntp.org
!
end