program load complete, entry point: 0x2040c8, size: 0x2084efac Boot Status 17 Config = SMP, Running = SMP Board type: 0x00100401 Card Capability = 0x00000000 BSP: Board type : ASR9K-RSP-I tracelogger: starting tracing in background ring mode tracelogger running with args: -startring -F 1 -F 2 czip:326:mount=/dev/shmem, image=0, remove=0x1 czip: strings=ffff2430, as=ffff28d8, num=0x340 czip: 356:start_addr=60185000, in_size=0x1d5c2ba8 Restricted Rights Legend Use, duplication, or disclosure by the Government is subject to restrictions as set forth in subparagraph (c) of the Commercial Computer Software - Restricted Rights clause at FAR sec. 52.227-19 and subparagraph (c) (1) (ii) of the Rights in Technical Data and Computer Software clause at DFARS sec. 252.227-7013. cisco Systems, Inc. 170 West Tasman Drive San Jose, California 95134-1706 Cisco IOS XR Software for the Cisco XR ASR9K, Version 5.3.4 Copyright (c) 2016 by Cisco Systems, Inc. /pkg/lib//install_debug_remote: No such file or directory Jun 19 22:20:06.339: Install Setup: Booting with committed software Initializing Punt-switch ... Initializing Punt-switch ... Set RP CPU Cluster port in DSA mode Init STP group for Cluster ports forwarding state control done Cluster: Boot Request Filter configured Cluster: Control Link monitor proto filter configured Successfully initialized punt-switch(26 ports). SPP has connected to PAKMAN.... SPP registered CPU port 4 with DPAA SPP Port Idx 0 MAC addr --> 00:70:72:00:00:08 RP/0/RSP0/CPU0:Jun 19 22:19:36.163 : imio[64]: %PLATFORM-IMIO-3-OPERATION_NOTIFY : imio_main: cold start RP/0/RSP0/CPU0:Jun 19 22:21:13.509 : wdsysmon[445]: %HA-HA_WD-4-DISK_ALARM : A monitored device alarm set by /disk0: RP/0/RSP0/CPU0:Jun 19 22:21:13.511 : wdsysmon[445]: %HA-HA_WD-4-DISK_WARN : A monitored device /disk0: is above 80% utilization. Current utilization = 91. Please remove unwanted user files and configuration rollback points. RP/0/RSP0/CPU0:Jun 19 22:22:36.201 : pwr_mgmt[366]: %PLATFORM-PWR_MGMT-3-IO_COMM_FAILURE : Power-module 0/PS0/M1/SP IO communication failure condition raised RP/0/RSP0/CPU0:Jun 19 22:22:41.677 : shelfmgr[392]: %PLATFORM-SHELFMGR_HAL-3-POWER_SUPPLY_REDUNDANCY : Power Supplies are not N+1 protected. RP/0/RSP0/CPU0:Jun 19 22:22:41.686 : envmon[208]: %PLATFORM-ENVMON-2-ENV_CONDITION : Outstanding environmental condition exists in the chassis RP/0/RSP0/CPU0:Jun 19 22:22:41.686 : envmon[208]: %PLATFORM-ENVMON-2-ENV_CONDITION : Outstanding environmental condition exists in the chassis RP/0/RSP0/CPU0:Jun 19 22:23:35.086 : canb-server[153]: %PLATFORM-CANB_SERVER-3-ALARM_INDICATION : Raise alarm from CBC in slot 0/FT0/SP, alarm code CBC_ALRM_PWR_A_FUSE_FAILED RP/0/RSP0/CPU0:Jun 19 22:23:35.681 : cfgmgr-rp[163]: %OS-DATACORRUPTION-1-DATAINCONSISTENCY : copy error : pkg/bin/cfgmgr-rp : (PID=196710) : -Traceback= 4a1b4140 4bbe742c 4a20aebc 4bbce3c4 4002ef4c 4002f59c 4002f92c 400354c4 4003558c 4a1d3a94 4a1d17a0 40021fe4 4a2213cc ios con0/RSP0/CPU0 is now available Press RETURN to get started. RP/0/RSP0/CPU0:Jun 19 22:23:41.522 : lrd[309]: %HA-LRD_inv-4-UNEXPECTED : Unexpected: lrdi_get_hwi_type: Unknown board type : 0x0 RP/0/RSP0/CPU0:Jun 19 22:23:41.542 : lrd[309]: %HA-LRD_inv-4-UNEXPECTED : Unexpected: lrdi_get_hwi_type: Unknown board type from slot: 0xe1 RP/0/RSP0/CPU0:Jun 19 22:23:41.544 : lrd[309]: %HA-LRD_inv-4-UNEXPECTED : Unexpected: lrdi_get_hwi_type: Unknown board type : 0x0 RP/0/RSP0/CPU0:Jun 19 22:23:41.544 : lrd[309]: %HA-LRD_inv-4-UNEXPECTED : Unexpected: lrdi_get_hwi_type: Unknown board type from slot: 0xe1 RP/0/RSP0/CPU0:Jun 19 22:23:41.547 : firmware_manager[231]: %HA-LRD_inv-4-UNEXPECTED : Unexpected: lrdi_get_hwi_type: Unknown board type : 0x0 RP/0/RSP0/CPU0:Jun 19 22:23:41.565 : firmware_manager[231]: %HA-LRD_inv-4-UNEXPECTED : Unexpected: lrdi_get_hwi_type: Unknown board type from slot: 0xe1 SYSTEM CONFIGURATION IN PROCESS The startup configuration for this device is presently loading. This may take a few minutes. You will be notified upon completion. Please do not attempt to reconfigure the device until this process is complete. Jun 19 22:24:37.379 : RP/0/RSP0/CPU0:Jun 19 22:24:37.376 : easybake3[187]: %INSTALL-TURBOBOOT-3-INVALID_DEVICE : The requested install device bootflash: is either corrupt or missing. Turboboot cannot be performed. The turboboot settings will be cleared, and the node will reset. Please repair or insert the device and retry the boot sequence. TURBOBOOT: Failed to obtain turboboot parameters: 'Turboboot' detected the 'fatal' condition 'No devices that qualifies for boot device are found in the system' Jun 19 22:24:37.399 : TURBOBOOT: Resetting TURBOBOOT rommon variable to (TURBOBOOT=). Jun 19 22:24:37.430 : TURBOBOOT: Setting config-register to NOT autoboot the router and NOT disable send break. Jun 19 22:24:37.488 : TURBOBOOT: Failed reading/validating turboboot settings: 'Turboboot' detected the 'fatal' condition 'No devices that qualifies for boot device are found in the system' Jun 19 22:24:37.489 : TURBOBOOT: *** RESET ▒▒Kc▒▒▒▒g▒▒▒:N▒▒▒▒▒▒▒▒sRԤ▒hU▒ѕ▒▒▒▒▒▒▒Ʌ▒▒U▒ͥ▒▒▒▒r▒▒B▒▒▒▒▒▒▒▒҂ʒ▒▒▒J▒5%▒Z▒▒ժ▒ʪ▒ ▒H▒h▒ Wɥ▒▒сB▒▒▒ʢj▒▒▒▒▒▒͍▒▒▒▒▒ѕ▒ͱJ卹jRԤ▒hԫ W▒▒$▒$▒S▒T▒▒)▒&M▒▒&$▒^H▒Z▒]▒▒a Starting Initialization of FMAN0 ***PPC PROCESSOR REV=2 load FMAN ucode*** Loading ucode for FMAN0, size: 6992, ver: 101.08.00 Starting Initialization of FMAN1 ***PPC PROCESSOR REV=2 load FMAN ucode*** Loading ucode for FMAN1, size: 6992, ver: 101.08.00 Serdes Protocol: 0x10 CPU Reset Reason = 0x0001 Initializing GIGE SW... PPC P40X0 (partnum 0x8023), Revision 02.00, (Core Version 02.00) Sys Clock: 100 Mhz Core Clock: 1500 Mhz Plat Clock: 800 Mhz LBC Clock: 25 Mhz MEM Clock: 1300 Mhz System Bootstrap, Version 2.04(20140227:092320) [ASR9K ROMMON], Copyright (c) 1994-2014 by Cisco Systems, Inc. Compiled Thu 27-Feb-14 14:53 by nidutta Board Type: 0x100401 CPU Board => Rev: 0x3 ========= FPGA ver: 01.0f CBC: 16.72 DTI programmed with latest image TIMEX programmed with latest image MLAN init done: ready to connect to the network BCM5482PhyInit () : Port 0 --> SFP Not present BCM5482PhyInit () : Port 1 --> SFP Not present set_chassis_type: chassis_type=0xef0400 found=TRUE ASR9001E (P40X0 PPC) RSP platform with 8192 Mb of main memory Boot Status 15 Serial ID: FOC1830N48K rommon B1 > PuTTY