MYLUTCCCES500#upgrade rom-monitor slot 1 sp file tftp://144.199.58.118/cat6000-sup2-rm2.7-1-1.srec Copying tftp://144.199.58.118/cat6000-sup2-rm2.7-1-1.srec onto SP's bootflash... Loading cat6000-sup2-rm2.7-1-1.srec from 144.199.58.118 (via vlan1):!!!!!!!!!!! !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! MYLUTCCCES500#show version Cisco Internetwork Operating System Software IOS (tm) c6sup2_rp Software (c6sup2_rp-PSV-M), Version 12.1(13)E17, RELEASE SOFTWARE (fc1) Technical Support: http://www.cisco.com/techsupport Copyright (c) 1986-2005 by cisco Systems, Inc. Compiled Wed 24-Aug-05 21:52 by tinhuang Image text-base: 0x40008C00, data-base: 0x417A8000 ROM: System Bootstrap, Version 12.1(3r)E2, RELEASE SOFTWARE (fc1) BOOTLDR: c6sup2_rp Software (c6sup2_rp-PSV-M), Version 12.1(13)E17, RELEASE SOFTWARE (fc1) MYLUTCCCES500 uptime is 3 days, 21 hours, 31 minutes Time since MYLUTCCCES500 switched to active is 3 days, 21 hours, 31 minutes System returned to ROM by power-on (SP by power-on) System restarted at 15:48:04 GMT Fri Mar 16 2007 System image file is "sup-bootflash:c6sup22-psv-mz.121-13.E17.bin" cisco Catalyst 6000 (R7000) processor with 227328K/34816K bytes of memory. Processor board ID SAD054305D9 R7000 CPU at 300Mhz, Implementation 39, Rev 2.1, 256KB L2, 1024KB L3 Cache Last reset from power-on X.25 software, Version 3.0.0. Bridging software. 2 Virtual Ethernet/IEEE 802.3 interface(s) 48 FastEthernet/IEEE 802.3 interface(s) 2 Gigabit Ethernet/IEEE 802.3 interface(s) 381K bytes of non-volatile configuration memory. 16384K bytes of Flash internal SIMM (Sector size 512K). Configuration register is 0x2012 MYLUTCCCES500#show module Mod Ports Card Type Model Serial No. --- ----- -------------------------------------- ------------------ ----------- 1 2 Catalyst 6000 supervisor 2 (Active) WS-X6K-S2U-MSFC2 SAD05430478 4 48 48 port 10/100 mb RJ45 WS-X6348-RJ-45 SAL04440TVN Mod MAC addresses Hw Fw Sw Status --- ---------------------------------- ------ ------------ ------------ ------- 1 0001.c9da.a64c to 0001.c9da.a64d 3.2 6.1(3) 7.5(0.6)HUB2 Ok 4 0003.6c11.e870 to 0003.6c11.e89f 1.4 5.4(2) 7.5(0.6)HUB2 Ok Mod Sub-Module Model Serial Hw Status --- --------------------------- --------------- --------------- ------- ------- 1 Policy Feature Card 2 WS-F6K-PFC2 SAD0543020U 2.0 Ok 1 Cat6k MSFC 2 daughterboard WS-F6K-MSFC2 SAD054305D9 1.2 Ok Mod Online Diag Status --- ------------------- 1 Pass 4 Pass MYLUTCCCES500#show rom-monitor slot 1 sp Region F1: APPROVED Region F2: APPROVED, preferred Currently running ROMMON from F2 region