AP1#sh run
Building configuration...

Current configuration : 2487 bytes
!
version 12.4
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
service password-encryption
!
hostname AP1
!
logging buffered 100000 informational
logging rate-limit console 9
enable secret xx
!
no aaa new-model
!
!
dot11 syslog
!
dot11 ssid Home
   vlan 1
   authentication open
   authentication key-management wpa version 2
   guest-mode
   mbssid guest-mode
   wpa-psk ascii 7 xxxxxxxxxx
!
dot11 ssid avnet
   vlan 2
   authentication open
   authentication key-management wpa
   mbssid guest-mode
   wpa-psk ascii 7 xxxx
!
!
!
username Cisco password 7 00271A150754
username cserve privilege 15 password 7 141447581E1279
!
!
bridge irb
!
!
interface Dot11Radio0
 no ip address
 no ip route-cache
 !
 encryption vlan 1 mode ciphers aes-ccm tkip
 !
 encryption vlan 2 mode ciphers aes-ccm tkip
 !
 ssid Home
 !
 antenna gain 0
 mbssid
 speed  basic-12.0 18.0 24.0 36.0 48.0 54.0 m0. m1. m2. m3. m4. m5. m6. m7. m8. m9. m10. m11. m12. m13. m14. m15.
 channel least-congested 2412 2437 2462 2472
 station-role root
 no dot11 extension aironet
 world-mode dot11d country-code GB indoor
!
interface Dot11Radio0.1
 encapsulation dot1Q 1 native
 no ip route-cache
 bridge-group 1
 bridge-group 1 subscriber-loop-control
 bridge-group 1 block-unknown-source
 no bridge-group 1 source-learning
 no bridge-group 1 unicast-flooding
 bridge-group 1 spanning-disabled
!
interface Dot11Radio0.2
 encapsulation dot1Q 2
 no ip route-cache
 bridge-group 2
 bridge-group 2 subscriber-loop-control
 bridge-group 2 block-unknown-source
 no bridge-group 2 source-learning
 no bridge-group 2 unicast-flooding
 bridge-group 2 spanning-disabled
!
interface GigabitEthernet0
 no ip address
 no ip route-cache
 duplex auto
 speed auto
 no keepalive
 hold-queue 80 in
!
interface GigabitEthernet0.1
 encapsulation dot1Q 1 native
 no ip route-cache
 bridge-group 1
 no bridge-group 1 source-learning
 bridge-group 1 spanning-disabled
!
interface GigabitEthernet0.2
 encapsulation dot1Q 2
 no ip route-cache
 bridge-group 2
 no bridge-group 2 source-learning
 bridge-group 2 spanning-disabled
!
interface BVI1
 ip address 192.168.100.51 255.255.255.0
 no ip route-cache
!
ip default-gateway 192.168.100.1
ip http server
no ip http secure-server
ip http help-path http://www.cisco.com/warp/public/779/smbiz/prodconfig/help/eag
bridge 1 route ip
!
!
!
line con 0
line vty 0 4
 login local
!
end