Building configuration... Current configuration : 2675 bytes ! ! No configuration change since last restart version 15.2 service timestamps debug datetime msec service timestamps log datetime msec no service password-encryption ! hostname Router ! boot-start-marker boot-end-marker ! ! enable secret 5 ******** enable password ******** ! no aaa new-model ! clock timezone SYDNEY 10 0 service-module wlan-ap 0 bootimage autonomous ! no ipv6 cef ! ! ! ! ! ip name-server 8.8.8.8 ip name-server 1.1.1.1 ip cef ! multilink bundle-name authenticated ! crypto pki token default removal timeout 0 ! ! license udi pid CISCO1941W-N/K9 sn ********** hw-module ism 0 ! ! ! ! redundancy ! ! ! ! ! controller VDSL 0/0/0 ! ! ! ! ! ! ! ! ! ! interface Embedded-Service-Engine0/0 no ip address shutdown ! interface GigabitEthernet0/0 ip address 192.168.101.1 255.255.255.0 ip nat inside ip virtual-reassembly in duplex auto speed auto no mop enabled ! interface wlan-ap0 description Service module interface to manage the embedded AP no ip address arp timeout 0 no mop enabled no mop sysid ! interface GigabitEthernet0/1 ip address dhcp ip nat outside ip virtual-reassembly in duplex auto speed auto ! interface Wlan-GigabitEthernet0/0 description Internal switch interface connecting to the embedded AP no ip address shutdown ! interface ATM0/0/0 no ip address shutdown no atm ilmi-keepalive ! interface Ethernet0/0/0 no ip address shutdown ! interface GigabitEthernet0/1/0 no ip address shutdown ! interface GigabitEthernet0/1/1 no ip address shutdown ! interface GigabitEthernet0/1/2 no ip address shutdown ! interface GigabitEthernet0/1/3 no ip address shutdown ! interface GigabitEthernet0/1/4 no ip address shutdown ! interface GigabitEthernet0/1/5 no ip address shutdown ! interface GigabitEthernet0/1/6 no ip address shutdown ! interface GigabitEthernet0/1/7 no ip address shutdown ! interface Vlan1 no ip address shutdown ! ip forward-protocol nd ! ip http server no ip http secure-server ! ip route 0.0.0.0 0.0.0.0 x.x.x.x 254 ip route 0.0.0.0 0.0.0.0 dhcp ! dialer-list 1 protocol ip permit ! ! ! ! ! snmp-server community public RO snmp-server enable traps entity-sensor threshold ! control-plane ! ! ! line con 0 line aux 0 line 2 no activation-character no exec transport preferred none transport input all transport output pad telnet rlogin lapb-ta mop udptn v120 ssh stopbits 1 line 67 no activation-character no exec transport preferred none transport input all transport output pad telnet rlogin lapb-ta mop udptn v120 ssh line vty 0 4 password ********** login transport input all ! scheduler allocate 20000 1000 ntp server 132.163.97.5 end