Welcome to the Community!
The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally.
New Here? Click here to learn more and get started.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1919044members
1223027discussions

Community Activity

Upgrade from SNS-3595-K9 to SNS-3795-K9

Hello, I have two ISE 3595 (3.2 Patch 3) physical appliances, one in each Data Centre. They will be end-of-life in a few months. They are currently used for Wired NAC with Posturing, Wireless NAC (corporate, BYOD and Guest and Hotspot). It is also us...

Resolved! Catalyst 3580 to 9300 Migration

Hi All , I am in the testing phase of migrating to a 9300. So far I have done the below.3850 running 16.3.6   and 9300 updated 17.09.04aI have copied the start-up config to the 9300 - all looks ok apart from the usual ip routes , some interfaces not ...

machine23 by Level 1
  • 41 Views
  • 2 replies
  • 0 Helpful votes

No console port connection

I am using a cable from Console to serial, and that cable connected from serial to usb and i am using PuTTY. I have tested this setup with a Catalyst 2960 switch and i got output, but when i am using the same configuration for the 2504 Wireless contr...

sandbox and vpn issues

good afternoon,  I believe I have everything downloaded like I should have and I'm pretty sure that I've established a secure VPN with cisco. For some reason I cannot see this import button like on the instructions under lab topology. it says I have ...

Networking

Hi everyone, I have a Cisco catalyst C1200-24P-4X switch, and I want to enable stacked VLAN configuration on it. Does it can support the feature?

moges1 by Level 1
  • 88 Views
  • 1 replies
  • 0 Helpful votes

Tacacs server configuration problem

Greeting everyone! There is a little problem with configuring tacacs server on ws-2950-24 model switch. The rest switches we have are 2960 series, also 3xxx series and others, more modern versions. We always configured tacacs server this way:tacacs-s...

IPSec tunnel encrypt packts but no decrypt

Hi Community, We have a newly established IKEV 1 tunnel from Cisco ASA to AWS. This tunnel is currently at up state but the traffic is not passing through the tunnel. When we enter the show command "show crypto ipsec sa peer X.X.X.X" output have enca...

naveen98 by Level 1
  • 108 Views
  • 6 replies
  • 0 Helpful votes

Dot1x Configuration in WS-C2960X-24TS-LL

I have Configured the 802.1x Configuration in WS-C2960X-24TS-LL Switch Globally. when i test the aaa test it was successful. but when i tried to configure in the Interface the authentication was not happening. so can you please help to configure the ...

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: