topic Re: CML LAB Not starting in DevNet Sandbox

CML LAB Not starting

karam.nashwan — Sat, 10 Apr 2021 13:59:44 GMT

Good Morning/Afternoon Everyone;

Yesterday I tried to use CML and it works fine, I reserved CML Personal for the 2H token and everything was normal.

However, today I was trying to do the same thing but the LAB is not started and the 2nd email that should be sent to me never arrived. Instead, I got the below-attached error.

Your help is highly appreciated.

Thanks.

Re: CML LAB Not starting

Martin L — Sat, 10 Apr 2021 19:01:27 GMT

Something happened on DevNet side; nothing you can do. Try new reservation after waiting few minutes or an hour or so;

Regards, ML
**Please Rate All Helpful Responses **

Re: CML LAB Not starting

tom_minerd — Thu, 22 Apr 2021 20:42:15 GMT

I'm currently experiencing issues getting into CML. It worked fine for me yesterday but today it will not complete the setup. So I tried doing a teardown of the lab so I could start over. Of course that didn't work so now I'm stuck at the concurrent lab limit but unable to get into my current lab.

Re: CML LAB Not starting

tom_minerd — Thu, 22 Apr 2021 21:02:50 GMT

This is the output from the reservation:

20:44:14 Environment Driver Setup has begun

Beginning sandbox setup
Preparing connectivity
Apps deployment started

Apps are being discovered...

Connecting all apps

Apps are powering on...

Waiting for apps IP addresses, this may take a while...

No apps to configure
Sandbox setup finished successfully

20:46:16 Just a moment - a few more things left to setup...

20:46:21 Setting POD Internet access policy

20:46:22 Waiting 4 minutes for all systems be become fully ready

20:50:25 Calling Setup on applicable resources

20:50:49 Beginning Setup for resource [Cisco Modeling Labs_2e6a-a0d5]

20:50:50 Beginning Setup for resource [DevBox_cf8b-a0d5]

Setting up Network policy
Done
Network Setup Complete!!!

20:51:03 Completed Setup for resource [DevBox_cf8b-a0d5]

Re: CML LAB Not starting

Martin L — Fri, 23 Apr 2021 00:18:36 GMT

I got same issue; it seems they doing upgrading or updating CML Or it is so busy they don't have any open sockets for us. I check later when it is not rush hour traffic but it seems to be missing from

https://devnetsandbox.cisco.com/RM/Topology

Regards, ML
**Please Rate All Helpful Responses **