topic Re: CML 2.2.2 Nodes are failing to load. in DevNet Sandbox

CML 2.2.2 Nodes are failing to load.

PiotrWikarski44780 — Sat, 14 Aug 2021 08:18:53 GMT

None of nodes that I put into a lab can start. There is a message of a timeout. I've even tried staring a single lab with a single router only. This does not seam to be cpu/memory issue as they are below 10%.

When I start the node, after around a minute warning timeout message pops out..

Re: CML 2.2.2 Nodes are failing to load.

PiotrWikarski44780 — Sat, 14 Aug 2021 08:35:46 GMT

Re: CML 2.2.2 Nodes are failing to load.

balaji.bandi — Sat, 14 Aug 2021 20:10:55 GMT

Looks like some installation issue, try to re-install as per the document and test.

https://community.cisco.com/t5/cisco-modeling-labs-discussions/can-t-start-nodes-in-cml/m-p/4444522

Re: CML 2.2.2 Nodes are failing to load.

Martin L — Sun, 15 Aug 2021 03:40:43 GMT

Is this still an issue? maybe your internet connection and/or vpn is the cause. what is your Internet speed ? have you check vpn software ? at least one other person had vpn software issue so it may not be you alone. see https://community.cisco.com/t5/devnet-sandbox/internet-issue-with-cisco-any-connect/m-p/4449461

Regards, ML
**Please Rate All Helpful Responses **