topic Re: NX-OS 9000 in DevNet Sandbox

NX-OS 9000

NarenB — Sat, 04 Feb 2023 19:03:25 GMT

Trying to set-up a simple topology using nxos9000 nodes and I see only three interfaces when using link connector to connect to other nodes. At one point I had seen more than that but lately I see only three interfaces. I need few more interfaces to create complete topology.

Has anyone else experienced same? Does anyone have a solution?

Thank you,

Naren

Re: NX-OS 9000

bigevilbeard — Sat, 04 Feb 2023 19:28:17 GMT

@NarenB whats this in CML, personal, ent, sandbox?

Re: NX-OS 9000

NarenB — Sat, 04 Feb 2023 19:52:46 GMT

CML

Re: NX-OS 9000

balaji.bandi — Sat, 04 Feb 2023 20:20:25 GMT

by default it should offer you 20 interfaces, if you like more you can add as below :

https://developer.cisco.com/docs/modeling-labs/#!adding-interfaces-and-overprovisioning

Re: NX-OS 9000

bigevilbeard — Sat, 04 Feb 2023 20:46:59 GMT

In the sandbox version?

Re: NX-OS 9000

NarenB — Sat, 04 Feb 2023 22:14:42 GMT

@bigevilbeard yes, in sandbox version. At one point there were 20 interface but after that I see only three to create "physical links".

Re: NX-OS 9000

NarenB — Sat, 04 Feb 2023 22:15:52 GMT

@balaji.bandi I need only 5 but I see only thee available Eth1/1-3

Re: NX-OS 9000

balaji.bandi — Sat, 04 Feb 2023 22:17:52 GMT

i was not sure on the sandbox, never used that should support it - I was keener to address using the personal edition.

SANDBOX - that may be a limitation not sure.

Re: NX-OS 9000

bigevilbeard — Sun, 05 Feb 2023 09:32:31 GMT

Put a ticket into the team, if this was 20 before something then has changed --> HERE