topic Re: Gateway for P1 and P2 in Web Security

Gateway for P1 and P2

kostasthedelegate — Fri, 16 Apr 2021 07:35:42 GMT

Hello,

I would like to set different gateway for M1, P1 and P2 in WSA

Is that possible?

How it is configured?

Thanks and regards,

Konstantinos

Re: Gateway for P1 and P2

Rob Ingram — Fri, 16 Apr 2021 13:28:53 GMT

Hi @kostasthedelegate

Yes this is possible. Each interface would be physically connected to a different VLAN and you specify the relevant default gateway. The WebUI location is network > interfaces tab.

HTH

Re: Gateway for P1 and P2

Ken Stieers — Fri, 16 Apr 2021 14:17:12 GMT

You can set default gateway for each interface as well any static routes you need on the Network/Routes page.

Re: Gateway for P1 and P2

kostasthedelegate — Fri, 16 Apr 2021 16:53:56 GMT

So I cannot have a separate gateway for P1 and a separate for P2?

Re: Gateway for P1 and P2

kostasthedelegate — Mon, 19 Apr 2021 07:32:29 GMT

The thing is that I have P1 and P2 with different gateways, but I cannot seem to be able to set them.

Re: Gateway for P1 and P2

hcombee — Mon, 19 Apr 2021 08:30:37 GMT

For data traffic there is one routing table, but you can set for instance a route for RFC1918 adresses to the gateway of P1 and a default route to the gateway of P1.