topic Re: SSL Content rule + service in Application Networking https://community.cisco.com/t5/application-networking/ssl-content-rule-service/m-p/682478#M12955 <HTML><HEAD></HEAD><BODY><P>if there is no port specified in the service definition, the CSS uses the destination port that was used by the client.</P><P></P><P>Gilles.</P></BODY></HTML> Mon, 19 Mar 2007 10:48:54 GMT Gilles Dufour 2007-03-19T10:48:54Z SSL Content rule + service https://community.cisco.com/t5/application-networking/ssl-content-rule-service/m-p/682477#M12954 <P>Hi kinde regards,</P><P></P><P>Supposse I have a layer 4 content rule as the following:</P><P>content appn_man </P><P> vip address 10.2.12.5 </P><P> add service proatriu2oa11a0 </P><P> add service problock2oa12a0 </P><P> advanced-balance sticky-srcip </P><P> sticky-inact-timeout 60 </P><P> protocol tcp </P><P> port 40001 </P><P></P><P>service proatriu2oa11a0 </P><P> ip address 10.3.5.15</P><P> active</P><P>How will the content rule forward this? Content rule will listen on port 40001 and will forward it to 40001? If there is no port specified in the service does it assume a default port?</P><P></P><P>Kind regards,</P><P></P><P>Frederik De Muyter.</P><P></P><P> </P><P></P> Mon, 19 Mar 2007 10:07:29 GMT https://community.cisco.com/t5/application-networking/ssl-content-rule-service/m-p/682477#M12954 Gomez 2007-03-19T10:07:29Z Re: SSL Content rule + service https://community.cisco.com/t5/application-networking/ssl-content-rule-service/m-p/682478#M12955 <HTML><HEAD></HEAD><BODY><P>if there is no port specified in the service definition, the CSS uses the destination port that was used by the client.</P><P></P><P>Gilles.</P></BODY></HTML> Mon, 19 Mar 2007 10:48:54 GMT https://community.cisco.com/t5/application-networking/ssl-content-rule-service/m-p/682478#M12955 Gilles Dufour 2007-03-19T10:48:54Z