topic Re: ACE Configuration Synchronization failure in Application Networking

ACE Configuration Synchronization failure

new_networker — Mon, 20 Oct 2008 10:11:46 GMT

I have defined the FT group on ACE, but i don't see configuration getting update on the other module.

The response for 'sh ft peer detail' is as follows

Peer Id : 1

State : FSM_PEER_STATE_DOWN

Maintenance mode : MAINT_MODE_OFF

FT Vlan : 200

My IP Addr : 1.1.1.1

Peer IP Addr : 1.1.1.2

Query Vlan : Not Configured

Peer Query IP Addr : 0.0.0.0

Heartbeat Interval : 200

Heartbeat Count : 20

Tx Packets : 0

Tx Bytes : 0

Rx Packets : 0

Rx Bytes : 0

Rx Error Bytes : 0

Tx Keepalive Packets : 0

Rx Keepalive Packets : 0

TL_CLOSE count : 0

FT_VLAN_DOWN count : 0

PEER_DOWN count : 1

SRG Compatibility : INIT

License Compatibility : INIT

FT Groups : 1

Please assist.

dario.didio — Mon, 20 Oct 2008 11:25:57 GMT

Can you please paste you configuration.

Did you configure both modules with the FT configuration?

Is the FT vlan available on both chassis?

Is the FT vlan trunked between the two chassis?

new_networker — Mon, 20 Oct 2008 11:40:50 GMT

Your first question was the answer. VLAN was missing on the second chassis.

Thanks.

dario.didio — Mon, 20 Oct 2008 12:09:40 GMT

you're welcome.