topic Re: CSS Source NAT for UDP packets in Application Networking https://community.cisco.com/t5/application-networking/css-source-nat-for-udp-packets/m-p/1116113#M22855 <HTML><HEAD></HEAD><BODY><P>Lukas,</P><P></P><P>the source-group command does not make any distinction between udp and tcp.</P><P>But, with UDP, since those connections have no SYN/FIN, they usually stay a long time in cache and your new source group won't have effect until you clear the flow.</P><P></P><P>Gilles.</P></BODY></HTML> Mon, 05 Jan 2009 09:43:13 GMT Gilles Dufour 2009-01-05T09:43:13Z CSS Source NAT for UDP packets https://community.cisco.com/t5/application-networking/css-source-nat-for-udp-packets/m-p/1116112#M22854 <P>Hello</P><P></P><P>Is it possible to configure the CSS to NAT the source IP addresses of UDP packets being transmitted through the CSS ?</P><P></P><P>I only managed to configure the load-balancer to NAT the src for TCP connections with "source group" feature.</P><P></P><P></P><P>Regards </P><P></P><P>Lukas</P> Wed, 31 Dec 2008 09:27:38 GMT https://community.cisco.com/t5/application-networking/css-source-nat-for-udp-packets/m-p/1116112#M22854 lukaszkhalil 2008-12-31T09:27:38Z Re: CSS Source NAT for UDP packets https://community.cisco.com/t5/application-networking/css-source-nat-for-udp-packets/m-p/1116113#M22855 <HTML><HEAD></HEAD><BODY><P>Lukas,</P><P></P><P>the source-group command does not make any distinction between udp and tcp.</P><P>But, with UDP, since those connections have no SYN/FIN, they usually stay a long time in cache and your new source group won't have effect until you clear the flow.</P><P></P><P>Gilles.</P></BODY></HTML> Mon, 05 Jan 2009 09:43:13 GMT https://community.cisco.com/t5/application-networking/css-source-nat-for-udp-packets/m-p/1116113#M22855 Gilles Dufour 2009-01-05T09:43:13Z