ACE Syslog message for State change

Bilal Nawaz — Wed, 13 Feb 2013 13:42:32 GMT

Hi,

Is there a syslog message for a state-change for rservers, if so how could we enable this?

e.g. when probe fails state changes to 'probe-failed'

when all probes are successful state is 'operational'

Thank you

Bilal

ACE Syslog message for State change

ajayku2 — Wed, 13 Feb 2013 14:58:59 GMT

Hi,

There is a syslog message something like below:

%ACE-3-251006: Health probe failed for server 10.80.10.10 on port 80 internal error: failed to setup a socket.

First enable logging on ACE.

ACE/Admin(config)# logging enable

http://www.cisco.com/en/US/docs/app_ntwk_services/data_center_app_services/ace_appliances/vA1_7_/configuration/system/message/guide/config.html#wp1063750

read the section:  Specifying Syslog Output Locations

logging buffered 3 should generate syslog in event of probe failure.

You can also set snmp to monitor it.

cesRealServerStateChange

CISCO-ENHANCED-
SLB-MIB

State of a real server configured in a server farm changed to a new state as a result of something other than a user intervention. This notification is sent for situations such as ARP failures, probe failures, and so on.

Hope that helps.

regards,

Ajay Kumar

topic ACE Syslog message for State change in Application Networking

ACE Syslog message for State change

ACE Syslog message for State change