topic waas-694 in Application Networking

waas-694

Srin_G — Wed, 31 Oct 2012 05:58:34 GMT

Hi Guys,

Bit new to this 674, when i try to configure an etherchannel group in the lan port it gives me error.

waecf23(config)#int gigabitEthernet 0/0

waecf23(config-if)#no shutdown

This interface can't be brought up

(No IP address, bridge-group, channel-group or standby configuration).

waecf23(config-if)#ip address 10.55.40.200 255.255.0.0

waecf23(config-if)#channel-group 1

GigabitEthernet 0/0 cannot be member of portchannel or standby group because BMC LAN channel is configured.

What i did before configuring the Etherchannel was to configure Gi0/0 as a normal port in the lab to upgrade the firmware and register with the CM. Now when i try to change the ip address and configure Etherchannel it gives me the above error.

Any ideas fellas?

regards

waas-694

Amir Asfandyarov — Wed, 31 Oct 2012 10:19:25 GMT

Hello Srini,

You can try to use "restore bmc-factory-default" to return bmc lan settings to its defaults.

Try this (if you're not using this), and let us know the results.

More info on IPMI interface - http://www.cisco.com/en/US/docs/app_ntwk_services/waas/waas/v445/release/notes/ws445xrn.html#wp154669 and http://www.cisco.com/en/US/docs/app_ntwk_services/waas/waas/v501/configuration/guide/other.html#wp1076258

Regards, Amir

waas-694

Srin_G — Wed, 31 Oct 2012 22:39:27 GMT

Thanks Amir. It worked.

cheers mate.

waas-694

anthony.brewley — Wed, 02 Oct 2013 12:44:45 GMT

Thank you Amir. This just fixed my issue on a WAVE-7541-K9.