topic Re: CiscoView for CSM in Application Networking

CiscoView for CSM

mslagel — Fri, 21 Jan 2005 02:15:50 GMT

Setup things according to the install doco.

did:

installed s/w properly on disk0:

enabled http

ip http path disk0:

However, when I open a browser to the ip address, I get not but no page found.

If I telnet to the ip address and port 80, I get a response so I know the webserver is running. The software is loaded to the / directory. I see a cv directory with files in it, and two othfiles at the / level.

home.html

home.shtml

Things seem right but no login prompt ever comes up?

Re: CiscoView for CSM

Gilles Dufour — Fri, 21 Jan 2005 15:13:41 GMT

did you install ciscoview for the catalyst as well ?

If I remember correctly, you access the CSM via the catalyst pages.

So are you able to view the cat6k ?

Regards,

Gilles.

Re: CiscoView for CSM

mslagel — Fri, 21 Jan 2005 16:45:58 GMT

I did install it yes. However, it is not a requirement. I will check on the second part of your question. Thanks for the reply.

Re: CiscoView for CSM

Gilles Dufour — Fri, 21 Jan 2005 16:58:52 GMT

ok - just tried it and it works.

ip http server

ip http authentication local

ip http path disk0:

And it works.

Did you configure the correct path ?

Also, if you want to access the csm module directly, the correct url is this

http:///flash/cv/applet.html?dynarchives=cvdm-csm-1.0.sgz&sl

otNo=

Where is the IP address of the switch and is the slot

number where CSM resides.

Otherwise, the default url is the Cat6k CVDM and from there you can select the CSM.

Regards,

Gilles.

Re: CiscoView for CSM

mslagel — Fri, 21 Jan 2005 18:50:55 GMT

you mentioned "did you configure the correct path". I have the three ip statements as you have. I tried you direct url and same thing. No page found

I have CVDM loaded also. If i point to the ip address, "no page found". In the / directory of disk0: is a cv directory, and two home.x files.

Re: CiscoView for CSM

mslagel — Mon, 24 Jan 2005 07:48:00 GMT

Note: I never get the login prompt either

Re: CiscoView for CSM

mslagel — Tue, 25 Jan 2005 00:41:56 GMT

finally get a login prompt. (not enough vty's).

Now things start to work but I am getting javascript errors....