topic Re: snmp on CE 2636 module in Application Networking https://community.cisco.com/t5/application-networking/snmp-on-ce-2636-module/m-p/361296#M6136 <HTML><HEAD></HEAD><BODY><P>So, you are saying that it should work for the 2636 modules as they are running ACNS? This was what I assumed too, but with the same snmp config that works successfully on the 565s, I can't get a response from the module.</P><P></P></BODY></HTML> Mon, 07 Feb 2005 23:27:20 GMT johcox 2005-02-07T23:27:20Z snmp on CE 2636 module https://community.cisco.com/t5/application-networking/snmp-on-ce-2636-module/m-p/361294#M6134 <P>I'm using the CISCO-CONTENT-ENGINE-MIB to get mrtg stats from CE565s. I cannnot see anywhere that it should not also work on the 2636 CE modules as both run the same version of ACNS, but it does not seem to.</P><P></P><P>Anyone tried this successfully with the 2636 module?</P><P></P><P>-Julianne</P> Wed, 02 Feb 2005 00:53:32 GMT https://community.cisco.com/t5/application-networking/snmp-on-ce-2636-module/m-p/361294#M6134 johcox 2005-02-02T00:53:32Z Re: snmp on CE 2636 module https://community.cisco.com/t5/application-networking/snmp-on-ce-2636-module/m-p/361295#M6135 <HTML><HEAD></HEAD><BODY><P>The ACNS 5.x software implementation of SNMP supports the following MIBs: </P><P></P><P>MIB-II </P><P>ENTITY-MIB </P><P>HOST-RESOURCES-MIB </P><P>CISCO-CONTENT-ENGINE-MIB </P><P>CISCO-ENTITY-ASSET-MIB </P><P>CISCO-CONFIG-MAN-MIB </P><P>CISCO-CDP-MIB </P><P>Could you please refer the link below which has more details about the CISCO-CONTENT-ENGINE-MIB </P><P><A class="jive-link-custom" href="http://www.cisco.com/en/US/products/sw/conntsw/ps491/products_configuration_guide_chapter09186a0080236630.html" target="_blank">http://www.cisco.com/en/US/products/sw/conntsw/ps491/products_configuration_guide_chapter09186a0080236630.html</A></P></BODY></HTML> Mon, 07 Feb 2005 20:11:44 GMT https://community.cisco.com/t5/application-networking/snmp-on-ce-2636-module/m-p/361295#M6135 pradeepde 2005-02-07T20:11:44Z Re: snmp on CE 2636 module https://community.cisco.com/t5/application-networking/snmp-on-ce-2636-module/m-p/361296#M6136 <HTML><HEAD></HEAD><BODY><P>So, you are saying that it should work for the 2636 modules as they are running ACNS? This was what I assumed too, but with the same snmp config that works successfully on the 565s, I can't get a response from the module.</P><P></P></BODY></HTML> Mon, 07 Feb 2005 23:27:20 GMT https://community.cisco.com/t5/application-networking/snmp-on-ce-2636-module/m-p/361296#M6136 johcox 2005-02-07T23:27:20Z