topic CSS11501 Loopback Question in Application Networking

CSS11501 Loopback Question

nayyarhak — Fri, 04 Nov 2005 09:59:33 GMT

I in the process of migrating from ios slb to css11501 and would like to know if:

Servers required to be configured with loopback addresses(as with IOS SLB) ?

What would be the effect of leaving the Loopbacks on the Server's

Thanks in advance for your responses.

Gilles Dufour — Fri, 04 Nov 2005 13:19:57 GMT

ios slb does not require the configuration of a loopback address.

This is only needed if you don't want to nat the vip into the server ip - most of the time because you want to do direct server return.

The CSS does not support direct server return.

If you were doing direct server return, be aware of this difference when doing your migration.

Since the CSS does not do DSR, you should do vip-2-real nating [the default] and therefore there is no need of a loopback address on the servers.

Regards,

Gilles.

nayyarhak — Fri, 04 Nov 2005 22:01:25 GMT

Hello

Thank you for your response.

I would appreciate any links you know that discusses this.

Thanks again.

Gilles Dufour — Sat, 05 Nov 2005 09:46:38 GMT

what exactly are you looking for ?

DSR not supported on CSS ?

or no loopback required if DSR not being used ?

I don't think you will find documentation talking expressly about this.

However, these questions came frequently on this forum and searching the forum should give you the same answer I gave you.

Finally, if you were using ios slb and need to migrate to hardware loadbalancer, the easiest solution is to go for a CSM.

You can then reuse your ios slb config.

Regards,

Gilles.