topic SSL module restart in Application Networking

SSL module restart

marcin.mazurek — Fri, 02 Dec 2005 22:34:24 GMT

Hi,

not very content networking specific but...

I'd like to reset SSL module in my 6509. When I try to set reload command in SSL I get this:

SSL_primary#reload at 3:00

Reload to the ROM monitor disallowed from a telnet line.

Set the configuration register boot bits to be non-zero.

and I have a register on SSL set to 0x0, but I can't find config-register command in SSL config mode. What would be the apropriate command to change register on module?

Is it possible to run "hw-module module 4 reset" to run and specific time?

tia

Re: SSL module restart

owillins — Thu, 08 Dec 2005 21:55:07 GMT

You will find the config-register command in the global config mode. You will find information on the usage of this command at http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124cr/hcf_r/cfn_02h.htm#wp1031618

Re: SSL module restart

marcin.mazurek — Fri, 09 Dec 2005 09:45:54 GMT

I think this is not this, as in MSFC I have already config-register set to correct value but on SSL module it's still 0x0.

thx