topic Re: CME ad-hoc conferencing in IP Telephony and Phones https://community.cisco.com/t5/ip-telephony-and-phones/cme-ad-hoc-conferencing/m-p/609129#M27 <HTML><HEAD></HEAD><BODY><P>CME does not use the hardware conferencing, it only uses software conference bridge, bascially the phone itself is the conf bridge, hence only 3 participants.</P><P>Hardware resources on CME can only be used for voice channels and transcoding.</P><P></P><P>HTH,</P><P></P><P>Chris</P></BODY></HTML> Mon, 27 Nov 2006 14:49:32 GMT Chris Deren 2006-11-27T14:49:32Z CME ad-hoc conferencing https://community.cisco.com/t5/ip-telephony-and-phones/cme-ad-hoc-conferencing/m-p/609128#M26 <P>I understand that CME only supports 3-way conferencing. Where is the conferencing actually performed? I have a 2801 with a PVDM2-8 and have configured 8 channels on a fractional PRI. I do not have any spare DSP resources available on the router and have not configured conferencing yet I can do a 3-way conference from my IP Communicator phone. My question is, where is the conferencing actually performed? Is it performed on the phones utilizing the built-in conference bridge?</P> Fri, 15 Mar 2019 01:58:18 GMT https://community.cisco.com/t5/ip-telephony-and-phones/cme-ad-hoc-conferencing/m-p/609128#M26 mbell 2019-03-15T01:58:18Z Re: CME ad-hoc conferencing https://community.cisco.com/t5/ip-telephony-and-phones/cme-ad-hoc-conferencing/m-p/609129#M27 <HTML><HEAD></HEAD><BODY><P>CME does not use the hardware conferencing, it only uses software conference bridge, bascially the phone itself is the conf bridge, hence only 3 participants.</P><P>Hardware resources on CME can only be used for voice channels and transcoding.</P><P></P><P>HTH,</P><P></P><P>Chris</P></BODY></HTML> Mon, 27 Nov 2006 14:49:32 GMT https://community.cisco.com/t5/ip-telephony-and-phones/cme-ad-hoc-conferencing/m-p/609129#M27 Chris Deren 2006-11-27T14:49:32Z