topic How can I monitor "Slip secs" and "Errored secs" in a Controller e1 interface? in Routing

How can I monitor "Slip secs" and "Errored secs" in a Controller e1 interface?

wahezu — Mon, 04 Mar 2019 16:04:05 GMT

Hi,

I would like to monitor "Slip errors" in a e1 interface from my monitoring Central system so I can setup an alarm when slip errors are encountered. It supports Syslog and SNMP.

I have been loooking for the SNMP OID objects but I couldn't find the correct one for slip errors. I don't know if it is possible to be performed by RMON.

Does somone implemented it before?

Re: How can I monitor "Slip secs" and "Errored secs" in a Contro

paolo bevilacqua — Thu, 08 Apr 2010 13:37:47 GMT

Have you configure network-clock-select ?

After you do that, there will be no more slip errors.

Re: How can I monitor "Slip secs" and "Errored secs" in a Contro

wahezu — Thu, 08 Apr 2010 14:49:56 GMT

Hi,

The network clock select is already setup and we don't have any problem with slip secs at the moment. But time to time the provider change the timing settings on the line without notifying me. Then I only notice the errors when I login to the router.

This is why I want to configure the monitoring system to trigger alarms when slip errors occur. My idea is to monitor also errored secs, crc , etc. I just stated Slip secs as an example.

Re: How can I monitor "Slip secs" and "Errored secs" in a Contro

paolo bevilacqua — Thu, 08 Apr 2010 15:31:57 GMT

Use the T1 / E1 MIB for that.

I am using MIB RFC1406, in

Paul Giles — Fri, 17 Jun 2016 13:43:17 GMT

I am using MIB RFC1406, in particular the OID 1.3.6.1.2.1.10.18.7.1.6 which is the number of Controlled Slip Seconds.