topic i cant put route map on the interface in Switching

i cant put route map on the interface

rgaleana06 — Thu, 07 Mar 2019 20:36:33 GMT

i have a tack the siwtche and i cant put a route map in the interface vlan

can you help me please, i have this ios in my stack

1 26 WS-C3750-24P 12.2(55)SE3 C3750-IPBASEK9-M

2 26 WS-C3750-24P 12.2(55)SE3 C3750-IPBASEK9-M

3 28 WS-C3750G-24PS 12.2(55)SE3 C3750-IPBASEK9-M

4 28 WS-C3750G-24PS 12.2(55)SE3 C3750-IPBASEK9-M

5 54 WS-C3750X-48P 12.2(55)SE3 C3750E-IPBASEK9-M

an i try to put this configuration

interface Vlan181

ip address 192.168.181.2 255.255.255.0

ip policy route-map name

i cant put route map on the interface

paul driver — Wed, 03 Apr 2013 14:55:42 GMT

Hello

What sdm template are you using- i think you need the routing template to apply PBR

sh sdm prefer

conf t

sdm prefer routing

you will need to reload stack for this to take affect.

res

Paul

Please don't forget to rate any posts that have been helpful.

Thanks.

i cant put route map on the interface

rgaleana06 — Wed, 03 Apr 2013 15:07:20 GMT

The current template is "desktop default" template.
The selected template optimizes the resources in
the switch to support this level of features for
8 routed interfaces and 1024 VLANs.

number of unicast mac addresses:                  6K
number of IPv4 IGMP groups + multicast routes:    1K
number of IPv4 unicast routes:                    8K
    number of directly-connected IPv4 hosts:        6K
    number of indirect IPv4 routes:                 2K
number of IPv4 policy based routing aces:         0
number of IPv4/MAC qos aces:                      0.5K
number of IPv4/MAC security aces:                 1K

i cant put route map on the interface

paul driver — Wed, 03 Apr 2013 15:13:06 GMT

Hello

So to apply policy based routing via route-map the sdm template needs to be "routing"

res

Paul

Please don't forget to rate any posts that have been helpful.

Thanks.

i cant put route map on the interface

rgaleana06 — Thu, 04 Apr 2013 04:46:31 GMT

i do it this procedure but i have the same problem

i cant put route map on the interface

cadet alain — Thu, 04 Apr 2013 06:02:19 GMT

Hi,

did you reload the switch for the new SDM template to take effect ?

Regards

Alain

Don't forget to rate helpful posts.

i cant put route map on the interface

alessandro.s — Thu, 04 Apr 2013 08:09:23 GMT

Hi Ricardo,

i think you have to run at least an IPSERVICE IOS to achieve this command. Your switches are all running IPBASE IOS.

Hope this helps.

Regards

i cant put route map on the interface

cadet alain — Thu, 04 Apr 2013 09:55:10 GMT

Hi,

Good catch

Regards

Alain

Don't forget to rate helpful posts.

i cant put route map on the interface

alessandro.s — Thu, 04 Apr 2013 14:21:04 GMT

Thanks!!

just too simple for you!

Regards

Alessandro