topic Do you have access to the in Switching

adding a new switch to the network....configuring internet access

khansen011 — Fri, 08 Mar 2019 07:09:03 GMT

Hey guys i need some help!

I am trying to set up my first switch. I am using the catalyst 2950 for learning on.

The network im on right now (the one with internet) has the following settings.

10.22.227.???
255.255.255.0
10.28.43.254

The one i am learning on i connect to it by going to 192.168.0.1 this will allow me into it using the Cisco Network Assistant.

I have a laptop on port 1 using Vlan1 and i have Desktop on port 24 with vlan 1 and i have a cable from our 10.22.227 network pluged into port 23

I am able to see the computers and i can share files on it. What i dont understand being a noob is why i dont have any internet on ether computer.

I have setup up port 23 as a switch.

It seams like to me i would have to give the switch a ip address a subnet mask a default gatway and a dns of the 10.22.227 network on port 23.

Can some one throw some light on the subject and point me in a good direction?

You will need to assign a

de fl — Tue, 31 Mar 2015 01:12:48 GMT

You will need to assign a default gateway at the very least. Can you ping any host outside your switch?

@de flIf i go to a computer

khansen011 — Tue, 31 Mar 2015 14:22:22 GMT

@de fl

If i go to a computer on the 10. network i can ping and go out and do everything i need to.

But if i try and ping with in the new switch (192) it does not work. I have added an ip address and a default gateway I have added a screen show on how our network is set up.

To me i think i need to add a ip address subnet mask and default gateway to the switch for the new switch to work.

How is the 192 switch

de fl — Tue, 31 Mar 2015 18:12:24 GMT

How is the 192 switch physically connected to the other switch?

it goes from 192 to a

khansen011 — Tue, 31 Mar 2015 19:47:06 GMT

it goes from 192 to a unmanaged switch to to 10. switch

Do you have access to the

de fl — Tue, 31 Mar 2015 19:57:45 GMT

Do you have access to the unmanaged switch? If not, can you connect a port on the 192 switch directly to a port on the 10 switch?

Yes the unmanaged switch is

khansen011 — Tue, 31 Mar 2015 21:39:02 GMT

Yes the unmanaged switch is sitting on my desk along with the 192 switch. The 10. switch i have access to but i have no controls over the functions or routing of that switch.

You would need to connect the

de fl — Wed, 01 Apr 2015 16:18:20 GMT

You would need to connect the unmanaged switch to the 10 switch, configure that port as an access port and assign it the correct vlan, and make the default gateway the same gateway as your PC. Do the same for the 192 switch.

Ok let me try this out and i

khansen011 — Wed, 01 Apr 2015 16:56:45 GMT

Ok let me try this out and i will post my findings when im done