topic HI, Can you please share a in Server Networking

vss 1440 Link aggregation in the port-channel

Richard Lucht — Thu, 01 May 2014 13:49:27 GMT

We are setting up a vss 1440 with 2 6509. I have 2 supervisor blades per chassis. I have 4 tengig ports on each switch in each port channel. we followed the configuration guide from CISCO. In a SH IP INT BR we only see one port on each switch in the port-channel as up. We want all ports up, after doing some research on the web I am still stuck. Does anyone have any ideas?

HI, Can you please share a

seemakha — Fri, 02 May 2014 05:18:08 GMT

HI,

Can you please share a couple of output:

show ether-channel summary

show module

show version

Also can you let me know which port-channel you are talking about and which line-card is the port-channel is?

Is it the VSL link you are concerned and if yes on which module is the VSL link connected to?

Regards,

Seemab

Hi, Thanks, we got it figured

Richard Lucht — Fri, 02 May 2014 13:53:07 GMT

Hi,

Thanks, we got it figured out. When we ordered the chassis they back ordered one sup720. When we got it we did not notice that it was not a 10G-3CXL, it was a 10G-3C. On the other chassis with the 2 correct blades we updated the IOS to the newest version on the active blade but not the standby. For the most part it is up and running on 3 sup blades.