topic Re: What about GPON in Cloud Networking Platform

What about GPON

MJU-NETDESIGN — Tue, 27 Nov 2018 21:20:03 GMT

Just wondering if Meraki has any plans for some GPON equipment.

Re: What about GPON

Philip D'Ath — Wed, 28 Nov 2018 00:12:35 GMT

Typically GPON is deployed with a standard copper Ethernet presentation. So there is nothing Meraki need to do.

How is it being deployed in your country that prevents it working with Meraki?

Re: What about GPON

jdsilva — Wed, 28 Nov 2018 04:21:16 GMT

@Philip D'Ath I took this to mean that @MJU-NETDESIGN is looking for a device to terminate the *PON fibre, likely onto the Internet side of an MX.

This is only my opinion, but I doubt that's ever going to happen. I don't see how it would make sense for Meraki to get into that business.

Re: What about GPON

Uberseehandel — Wed, 28 Nov 2018 12:00:07 GMT

Isn't GPON a MNO gig?

Re: What about GPON

Nolan H. — Wed, 28 Nov 2018 14:41:08 GMT

Ubiquiti has a whole selection for that stuff. I don't see Meraki ever getting into that world.

https://fiber.ubnt.com/

Re: What about GPON

Uberseehandel — Wed, 28 Nov 2018 17:16:24 GMT

UBNT supplies kit to many regional and niche operators. As far as I am aware, this is not a market Meraki intends operating in.

Re: What about GPON

RTHRESHIER1 — Thu, 29 Nov 2018 06:25:50 GMT

GPON fiber solutions is typically just a layer 2 transport so though the gear may not be Meraki, I don't see why you couldn't have a Meraki switch connected to a GPON ONT through your fiber cabling to a GPON OLT where it uplinks to a Meraki core/MX Appliance. Network topology view would still show non-Meraki components as long as it supports CDP/LLDP. Maybe I am wrong, my wife says I am all the time.

Re: What about GPON

Philip D'Ath — Thu, 29 Nov 2018 06:32:30 GMT

Time to upgrade your wife.

Re: What about GPON

MJU-NETDESIGN — Mon, 03 Dec 2018 20:17:44 GMT

i was planning to use it for a small FTTH project with 200 users.

I know there are others vendors, but i just think it would be nice to have meraki end to end.

And also have a enabled API network gear...

Re: What about GPON

Sanique — Fri, 16 Jun 2023 22:05:47 GMT

We have a similar setup. However, we cannot pass VLAN information from the Meraki MX to the Meraki switch. DHCP Dies through the Calix GPON ONT to the Access Point Clients. DHCP is fine however from the AP's isolated NAT10.0.0.0/8

I have been searching for a solution to this for a very long time.

If the access point is connected directly to the ONT Bridged DHCP is fine. However, if it goes through a Switch I get no DHCP from the local network.

Re: What about GPON

DainBrammage — Fri, 30 Jun 2023 18:16:03 GMT

Use the GPON as dumb transport only. Tunnel the APs back to an MX on the OLT side...

several options...