Meraki Documentation Digest: April 30th-May 7th, 2026

Change: Added "When enrolling a large number of sites, using templates allows the administrator to do so in one step. If sites are not using templates, it is recommended to enroll sites in batches of 200, allowing the UI to fully complete enrollment before proceeding with enrollment of another batch."

Security & SD-WAN:

Meraki MX ThousandEyes Configuration Guide

Change: Added "The account that performs the linkage must be a full-access organization administrator."

Cisco Meraki Local Status Page: Security and SD-WAN

Change: Added section "vMX Local status page".

IPv6 Support on MX Security & SD-WAN Platforms - WAN

Change: Added "The static IPv6 assignment on the WAN interface(s) is limited to a /64 prefix only."

Switching:

MS Switch Access Policies (802.1X)

Change: Added "The Critical Authentication VLAN feature is supported in Single Host, Multi Host, Multi Domain, and Multi Auth modes on Cisco Catalyst switches running IOS XE 17.15 or later. This feature is not supported on CS 17 firmware. Customers using CS17 must upgrade to IOS XE 17.15 or newer to utilize this feature."

Cloud Management with IOS XE

Cloud Management with IOS XE Overview

Change: Added "IOS XE 17.18.3 introduces Uplink Auto-Configuration (UAC) to enhance network reliability, alongside Sticky MAC allowlist and new cloud fabric features."

Cloud Configuration: Release Versions and Highlights

Change: Added section "Additional Features in 17.18.3".

Enable Cloud Management for Cisco Switches with Device Configuration

Change: Added "Port Channel Subinterfaces are Not Supported as Routed Uplinks in Configuration Source: Device - When a Catalyst switch uses a port-channel subinterface (e.g. Port-channel 14.1460), Dashboard cannot resolve a valid uplink for the switch. As a result, the uplink arrow does not appear in Dashboard and uplink telemetry is not populated."

Independent Firmware Releases for Meraki and Catalyst-based switches

Change: Added "CS software is being sunset (End of Support) and will no longer be developed going forward. Use Cloud Management as the replacement and refer to the Cloud Management documentation for guidance."

Cloud-Managed EVPN Fabric Overview

Change: Added EVPN Multihoming and 9500H.

Wireless:

RF Profiles

Change: Added section "(MR 33.1.1) 3 Radio Support".

Dynamic Frequency Selection (DFS)

Change: Updated section "(MR 33.1.1) Zero Wait DFS".

AP Auto Locate

Change: Updated amount of access points required: "Please ensure that each floor has a minimum of five access points in the network. Four APs will be placed as anchors, and at least one of them will be auto-placed."

Cloud Monitoring for Wireless - What's New

Change: Added section "May 2026".

Cloud Monitoring for Wireless Requirements

Change: Added CW9800L; added "There is a hard limit of 2,000 access points joining to the dashboard."; added "If the WLC supports less than 2,000 APs (ex. CW9800M and CW9800L), there is not a hard limit of onboarding the APs to dashboard. However, the numbers above are what was tested and supported as well as officially recommended. If more APs are joined, there can be performance and stability concerns."

Cloud Monitoring for Wireless FAQ

Change: Added CW9800L.

Cameras:

Firmware Updates on MV Smart Cameras

Change: Added section "Rolling Back to Older Firmware".

Platform Management:

Getting Started Checklist

Change: Updated to incorporate the Order Claim Key.

AI Assistant for Networking - Product Updates

Change: Added "Multimodal Image Upload is now GA in AI Assistant, enabling users to upload screenshots and diagrams to get instant explanations, grounded validation against Dashboard data, and faster troubleshooting - without translating visuals into text."

Clients Usage Page Overview

Change: Added section "(MR 33.1.1) Apple Analytics/WPA3 in Solicited Beacon".

AI Assistant for Networking

Change: Added FAQ "Can I deactivate the AI Assistant?".

Subscription - Unified Licensing Wi-Fi 7 APs

Change: Added "AI-RRM" and "Intelligent Capture"; Added CW9174I, CW9174E and CW9179F.

Network Alerts and Notifications

Change: Added sections "Receiving Email Alerts via SMS" and "Alert Aggregation".

MR, MX, Z, and MG Regulatory Domains

Change: Added "It's expected behavior after changing the regulatory domain/country settings, the APs to stop serving clients for several minutes. It may be required to manually set the country for networks where access points (APs) might switch to geo-located public IP addresses over time—such as in certain SD-WAN scenarios—due to failover events or traffic load balancing (under Network-wide > Configure > General). This manual configuration ensures compliance with country-specific regulatory requirements despite changes in the APs' public IP geo-location."

Cisco Meraki Local Status Page: Overview

Change: Added section "Cloud Environments".

Creating and Deleting Dashboard Networks

Change: Added "If the AutoVPN feature is enabled, the network cannot be deleted until it's disabled."

Cisco Meraki China Region

Change: Added "Cloud Monitoring for Wireless".

Moving Devices between Networks

Change: Added "Scheduled tags must be recreated."

Meraki and Catalyst Center Global Overview

Change: Updated the max. number of total organizations to 30; added "Support for 50 total organizations per administrator will available soon."; added "3.1.6 with GSMU 200 (Controlled Availability)" and "3.2.2 (currently Controlled Availability)".

Re: Meraki Documentation Digest: April 30th-May 7th, 2026

JamesT91 — Mon, 11 May 2026 08:56:09 GMT

@AmyReyes this one is completely blank for me: Configuration History and Restore - Cisco Meraki Documentation

Re: Meraki Documentation Digest: April 30th-May 7th, 2026

AmyReyes — Mon, 11 May 2026 16:01:06 GMT

Thanks for reporting this @JamesT91! I am seeing the same issue.

The Documentation team is investigating, and I'll follow up with you when we have a resolution.

ETA: This article is still under internal review and should not be public. Its privacy setting has been changed to reflect this, so it will now throw a red "Internal Only" banner for anyone who visits. I'll also remove it from the above Documentation Digest. Thanks again for flagging this to us!

Re: Meraki Documentation Digest: April 30th-May 7th, 2026

JamesT91 — Tue, 12 May 2026 09:01:31 GMT

Makes sense, thanks for the info!

topic Re: Meraki Documentation Digest: April 30th-May 7th, 2026 in Cloud Networking Platform

Meraki Documentation Digest: April 30th-May 7th, 2026

Re: Meraki Documentation Digest: April 30th-May 7th, 2026

Re: Meraki Documentation Digest: April 30th-May 7th, 2026

Re: Meraki Documentation Digest: April 30th-May 7th, 2026