https://community.cisco.com/t5/webex-devices/webex-control-hub-templates-macros-ui-editor-buttons/m-p/4618697#M738 <P>Can Macros/UI Buttons be templated from Webex Control Hub so that they can be applied to endpoints as they are registered en mass instead of on an individual basis? From what I see right now it looks like you can only enable/disable the macro engine, and has no options for UI Editor.</P> Thu, 26 May 2022 15:46:32 GMT Brett Heroux 2022-05-26T15:46:32Z https://community.cisco.com/t5/webex-devices/webex-control-hub-templates-macros-ui-editor-buttons/m-p/4618697#M738 <P>Can Macros/UI Buttons be templated from Webex Control Hub so that they can be applied to endpoints as they are registered en mass instead of on an individual basis? From what I see right now it looks like you can only enable/disable the macro engine, and has no options for UI Editor.</P> Thu, 26 May 2022 15:46:32 GMT https://community.cisco.com/t5/webex-devices/webex-control-hub-templates-macros-ui-editor-buttons/m-p/4618697#M738 Brett Heroux 2022-05-26T15:46:32Z https://community.cisco.com/t5/webex-devices/webex-control-hub-templates-macros-ui-editor-buttons/m-p/4618775#M739 <P>AFAIK the UI part is not yet available in Control Hub. On a side note Webex hasn’t been spelled as WebEx for a few years.</P> Thu, 26 May 2022 19:15:25 GMT https://community.cisco.com/t5/webex-devices/webex-control-hub-templates-macros-ui-editor-buttons/m-p/4618775#M739 Roger Kallberg 2022-05-26T19:15:25Z