topic Cisco Jabber Client - QoS Config in Collaboration Applications

Cisco Jabber Client - QoS Config

jjcollaguazo — Sun, 17 Mar 2019 21:12:13 GMT

Hi Guys,

I'll be deploying the new jabber client for a customer and i'm unsure of what QoS to configure on the switch ports for end users. Users will also have 7942 handsets, so if i configure auto qos voip cisco-phone, I doubt this will protect the voice/video for Jabber.

Has anyone got any config or tips they can share?

Cheers,

James

Cisco Jabber Client - QoS Config

ronpatel — Thu, 22 Dec 2011 03:20:05 GMT

Hi James,

For jabber QoS we should have a DSCP value where the signal is CS3 and the media is the DSCP value passed down from UCM.

Regards

Ronak Patel

Cisco Jabber Client - QoS Config

jjcollaguazo — Thu, 22 Dec 2011 05:01:34 GMT

HI Ronak,

So are you saying there is no auto QoS for Jabber? So do i just configure MQC using ACLs and apply the sevice policy to all LAN interfaces with the Jabber client?

Cisco Jabber Client - QoS Config

ronpatel — Thu, 22 Dec 2011 05:20:38 GMT

Hi,

I believe you can use "auto qos voip cisco-softphone"

Please see below QOS SRND.

http://www.cisco.com/univercd/cc/td/doc/solution/esm/qossrnd.pdf

Regards

Ronak

Cisco Jabber Client - QoS Config

jjcollaguazo — Sat, 11 Feb 2012 03:29:27 GMT

Hi Ronak,

Thanks for the reply, thats the same conclusion i came to after reading the QoS SRND. Just wanted to see what others thought.

Cheers,

James

Guys,

safwan riyazudeen — Thu, 10 Aug 2017 20:03:58 GMT

Guys,

I have a question to this thread,

When user connects his laptop to the physical IP Phone Port(daisy-chained), and uses cisco jabber to answer the calls instead of hard phone. How can we trust Both Soft Phone and Hard Phone in single Port?

It is not possible to apply both the Below commands.

auto qos voip cisco-phone

auto qos voip Cisco-softphone

Any inputs?

Regards

Safwan