topic Re: Compare commands in Collaboration Applications

Compare commands

Pragash22 — Wed, 16 Sep 2020 02:06:34 GMT

Hi Team

I need to migrate from 2811 to 4331, some commands are changed (Clocking configs in E1) on the new-model and the way we configure is bit different. This is router is mostly used for voice services and E1 card, FXO and FXS.

Earlier we had a option to compare commands in Cisco Feature Navigator, now I am not able to see 2811 image on feature navigator new version. That is really easy when comparing 2 versions and I will have less work to do. Now feature Navigator not like before and I was not able to compare.

Does anyone know any tools to compare or command reference would be the only solution?
Kind regards

Re: Compare commands

Nithin Eluvathingal — Wed, 16 Sep 2020 02:30:50 GMT

4321 controller configuration. this from a MGCP router. FXO and FXS its same.

card type e1 0 1

controller E1 0/1/0

clock source line primary

pri-group timeslots 1-10,16 service mgcp

network-clock synchronization automatic

network-clock input-source 1 controller E1 0/1/0

Re: Compare commands

Roger Kallberg — Wed, 16 Sep 2020 06:05:27 GMT

The generation of router your migrating from is well past end of life. That’s probably why you don’t see it in feature navigator. Although I never used the functionality you describe, quite frankly I didn’t even know it existed. With a small amount of effort and time you aught to be able to find and figure out the differences between the two platforms. Likely within the first migration you would nail it down and then you should be able to get the rest of your routers replaced with ease.

Re: Compare commands

Pragash22 — Wed, 16 Sep 2020 12:03:53 GMT

Nithvin

Thank you for your reply.

refer to the attach photo, do you have any why i get the error like attached. This is a 4K router. I could see the config for the interface Serial0/1/015 in the sh run as well. I assume that serial port not initiated correctly.

Kind regards

Pragash

Re: Compare commands

Pragash22 — Wed, 16 Sep 2020 11:58:42 GMT

Yeah these are very old technologies, but still many customers using it. Thanks for the words Rodger, referred to the documentation, now feel better :-D.

I have rarely worked with 28XX router from starting of my career.