topic IP Transit handoff configuration problem in Cisco Catalyst Center

IP Transit handoff configuration problem

rasmus.elmholt — Sat, 13 Jun 2020 21:54:27 GMT

Hi,

I have a pretty simple setup with a single 9300 Switch as C|B|E and configured 2 VNs on the device.

I am not trying to make a handoff towards a router but I cannot get the DNAC to bush the Border configuration to the device.

Every time I try it only gives me an error with:

Provisioning failed due to invalid parameter. The interface gigabitethernet1/0/24 on Device a6aa*******16 has an IP, remove the IP and then use the interface.

On interface Gi1/0/24 i have the following configuration and I have resynced the device:

interface GigabitEthernet1/0/24
 device-tracking attach-policy IPDT_MAX_10
end

Any advise would be appreciated.

Re: IP Transit handoff configuration problem

rasmus.elmholt — Sat, 13 Jun 2020 22:27:47 GMT

5 minuttes later everything worked.

Re: IP Transit handoff configuration problem

Benjamin-A — Sun, 14 Jun 2020 06:48:41 GMT

Hi, nice it worked.
Just wanted to share a tip:
Have a look at Kibana (System Settings > Sytem 360 > Log Explorer) and search for: log:error AND <device ip address>
It will show you a more detailed error message - helped me a lot in such szenarios. (:

Re: IP Transit handoff configuration problem

rasmus.elmholt — Sun, 14 Jun 2020 10:39:22 GMT

Looks like logs are not configured per default?

Looks like you don't have any logging indices.
Let's add some!

Or am I in the wrong place?