https://community.cisco.com/t5/endpoint-security/amp-for-endpoint/m-p/2972089#M1701 <P>During a trial, the customer has accidently deleted the default protect policy.</P> <P>How can this be restored? so it will be seen during a quick start.</P> <P>I know you can make your own policies, but even then how can this be attached to the defaults.</P> <P></P> Fri, 21 Feb 2020 05:01:26 GMT ron.hehemann1 2020-02-21T05:01:26Z https://community.cisco.com/t5/endpoint-security/amp-for-endpoint/m-p/2972089#M1701 <P>During a trial, the customer has accidently deleted the default protect policy.</P> <P>How can this be restored? so it will be seen during a quick start.</P> <P>I know you can make your own policies, but even then how can this be attached to the defaults.</P> <P></P> Fri, 21 Feb 2020 05:01:26 GMT https://community.cisco.com/t5/endpoint-security/amp-for-endpoint/m-p/2972089#M1701 ron.hehemann1 2020-02-21T05:01:26Z https://community.cisco.com/t5/endpoint-security/amp-for-endpoint/m-p/2972090#M1721 <P>Hello Ron,</P> <P>Unfortunately there is no way to restore the protect policy that you deleted. You need to create policies again.</P> <P>Rate if the post helps you</P> <P>Regards</P> <P>Jetsy&nbsp;</P> Tue, 26 Jul 2016 13:48:42 GMT https://community.cisco.com/t5/endpoint-security/amp-for-endpoint/m-p/2972090#M1721 Jetsy Mathew 2016-07-26T13:48:42Z