https://community.cisco.com/t5/endpoint-security/policy-isolation/m-p/4550687#M6669 That is correct. Is it possible to apply to an entire set of devices within a policy?<BR /> Fri, 11 Feb 2022 15:47:20 GMT nastudi1 2022-02-11T15:47:20Z https://community.cisco.com/t5/endpoint-security/policy-isolation/m-p/4549873#M6665 <P>Can the Isolation feature be applied to an entire policy instead of induvial devices?</P> Thu, 10 Feb 2022 20:01:42 GMT https://community.cisco.com/t5/endpoint-security/policy-isolation/m-p/4549873#M6665 nastudi1 2022-02-10T20:01:42Z https://community.cisco.com/t5/endpoint-security/policy-isolation/m-p/4550685#M6668 Are you asking if you can click on all machines in a policy/group and isolate them at the same time?<BR /> Fri, 11 Feb 2022 15:43:20 GMT https://community.cisco.com/t5/endpoint-security/policy-isolation/m-p/4550685#M6668 Ken Stieers 2022-02-11T15:43:20Z https://community.cisco.com/t5/endpoint-security/policy-isolation/m-p/4550687#M6669 That is correct. Is it possible to apply to an entire set of devices within a policy?<BR /> Fri, 11 Feb 2022 15:47:20 GMT https://community.cisco.com/t5/endpoint-security/policy-isolation/m-p/4550687#M6669 nastudi1 2022-02-11T15:47:20Z https://community.cisco.com/t5/endpoint-security/policy-isolation/m-p/4550695#M6670 As far as I can tell, no, not from the gui...<BR />You could script something from the API, but even then that would be a "grab all machines in group, for each group set isolation = true"<BR /> Fri, 11 Feb 2022 15:58:20 GMT https://community.cisco.com/t5/endpoint-security/policy-isolation/m-p/4550695#M6670 Ken Stieers 2022-02-11T15:58:20Z