topic ISE No EAP response from Client in Network Access Control

ISE No EAP response from Client

Adam White — Mon, 11 Mar 2019 03:38:18 GMT

Hi,

So on the same switch, same port configuration, 1 users laptop has absoutely no issues authenticating on the port.

On another port, same configuration, I see the below error in ISE.

Same windows settings on both laptops regarding the 802.1x authentication.

No response received during 120 seconds on last EAP message sent to the client :

5411 No response received during 120 seconds on last EAP message sent to the client

Any ideas as to why or whats happening here?

ISE No EAP response from Client

Jatin Katyal — Thu, 11 Jul 2013 10:46:16 GMT

This is more of supplicant issue. Could you please update the NIC drivers of the machine in question and try again.

~BR
Jatin Katyal

**Do rate helpful posts**

ISE No EAP response from Client

Adam White — Thu, 11 Jul 2013 10:57:30 GMT

Thanks!

Let me do driver updates and test a bit more

ISE No EAP response from Client

Ravi Singh — Mon, 15 Jul 2013 03:51:44 GMT

Verify that supplicant is configured properly to conduct a full EAP conversation with ISE. Verify that NAS is configured properly to transfer EAP messages to or from supplicant. Verify that supplicant or network access server (NAS) does not have a short timeout for EAP conversations. Check the network that connects the NAS to ISE. If the external ID store is used for the authentication, it may be not responding fast enough for current timeouts. For more information you can see the below link.

http://www.cisco.com/en/US/solutions/collateral/ns340/ns414/ns742/ns744/docs/howto_81_troubleshooting_failed_authc.pdf

ISE No EAP response from Client

Eduardo Aliaga — Mon, 15 Jul 2013 06:14:27 GMT

Hello Adam, please click that log to see the details and post them here. There are several reasons which can cause the "No response received during 120 seconds on last EAP message sent to the client " log and the details almost always tell us what's the specific issue.

ISE No EAP response from Client

Venkatesh Attuluri — Mon, 15 Jul 2013 08:41:04 GMT

manually start the Wired AutoConfig service To do this, follow these steps:
1. Click Start, and then click Run.
2. Type services.msc in the Open box, and then press ENTER.
3. Locate the Wired AutoConfig service, right-click it, and then click Start.