topic Re:ISE and MS Active Directory Integration Issue in Network Access Control

ISE and MS Active Directory Integration Issue

Rick Daoust — Mon, 11 Mar 2019 03:45:46 GMT

It appears that our ISE 1.2 solution is having issues with nested MS AD Groups. The first login attempt always fails, the second occasionally works and the third always works. Has anyone else experience this login issues with ISE 1.2 and MS AD?

Sent from Cisco Technical Support iPhone App

Re:ISE and MS Active Directory Integration Issue

Tarik Admani — Tue, 13 Aug 2013 04:30:23 GMT

Hi,

When you look at the authentication details do you see the groups listed in the additional attributes? Also are there any other condition such as endpoint groups in combination with the authorization policy. Can you provide a screenshot od your policies?

Sent from Cisco Technical Support Android App

Re:ISE and MS Active Directory Integration Issue

Rick Daoust — Tue, 13 Aug 2013 18:32:59 GMT

Hi Tarik,

Please see screenshots below:

Thanks,

Re:ISE and MS Active Directory Integration Issue

blenka — Wed, 14 Aug 2013 02:07:13 GMT

Please check the information and steps to integrate Active directory.

http://www.cisco.com/en/US/docs/security/ise/1.2/user_guide/ise_man_id_stores.html#wp1317829

ISE and MS Active Directory Integration Issue

Tarik Admani — Wed, 14 Aug 2013 02:32:19 GMT

Basant,

The integration against active directory is working fine he is having issues with consistency. Does the link provided above address consistency issues?

Tarik Admani
*Please rate helpful posts*

ISE and MS Active Directory Integration Issue

Tarik Admani — Wed, 14 Aug 2013 02:37:28 GMT

Rick,

I am a little lost in the screenshots you posted. In your AD groups that you have pulled I dont see an authorization policy mapped to the first group. In the authentication report it looks like authentication is successfull.

I have seen that ISE will only display a few of the groups now in ISE 1.2 can you build a policy based on the the group you want it to show and then try your authentication again? That is when ISE will show the specific group as opposed to ise pre 1.2 where it would show more groups.

Thanks,

Tarik Admani
*Please rate helpful posts*