topic ISE installation - reimaging issue in Network Access Control

ISE installation - reimaging issue

contactabbas — Mon, 11 Mar 2019 03:42:12 GMT

Hi,

Today I was installing ISE on 3355 appliances those will run all services (standalone), when installation completed I was not able to login to the CLI. I think the keyboard I used had issue (typed extra charachter or something). This was a pre-loaded OS.

I downloaded (ise-ipep-1.2.0-899.i386.iso) and tried password recovery booting appliance with (ise-ipep-1.2.0-899.i386.iso), after changing the password I saved configs and tried logging using the new password. But I could not login again.

Then I tried to re-install ISE using (ise-ipep-1.2.0-899.i386.iso). After the installation was completed, I entered setup command and an error poped up on the screen. "input/output errors occured while installation".

Question 1: Is the following iso only for a posture node installation or I could use this for ISE standalone deployment?

ise-ipep-1.2.0-899.i386.iso

Cisco Identity Services Engine Software Version 1.2.0 full installation (IPN functionality only). This ISO file can be used for installing ISE IPN (Inline Posture Node) on ISE-33x5 and NAC-33x5 Appliances, SNS-3415 server and CSACS-1121.

Question:2 What could have caused "input/output errors occured while installation". And how should I proceed with the installation?

I am in really bad situation, your help and support will be highly appreciated.

Regards

ISE installation - reimaging issue

Ravi Singh — Tue, 30 Jul 2013 01:59:53 GMT

Yes you are right the ise-ipep-1.2.0-899.i386.iso is used for installing ISE IPN. Might be you are using the corrupt software for Cisco Identity Services Engine. please download the latest software again. I installed the same and it’s working.

ISE installation - reimaging issue

contactabbas — Tue, 30 Jul 2013 17:19:43 GMT

Hi Ravi, Thanks for the reply but my questions were following..

Question 1: Is the following iso only for a posture node installation or I could use this for ISE standalone deployment?

Can I use this ise-ipep-1.2.0-899.i386.iso for fresh installation on 3355 appliance?

Question:2 What could have caused "input/output errors occured while installation". And how should I proceed with the installation?

Answer: Download the latest version 1.2 and check the MD5 checksum.

ISE installation - reimaging issue

Ravi Singh — Wed, 31 Jul 2013 08:18:11 GMT

Hello Mudasir,

I am checking that you will be able to deploye it in standalone mode or not. I will update the thread as soon as possible.

ISE installation - reimaging issue

Venkatesh Attuluri — Thu, 29 Aug 2013 13:41:07 GMT

If you wish to do a standlone deployment use

Cisco ISE Software Version 1.2.0 full installation(no IPN functionality).This ISO file can be used for installing ISE on ISE-33x5, NAC-33x5 Appliances, SNS-34x5 Servers and CSACS-1121 as well as a VM installation on VMWare ESX/ESXi 4.x/5.x

ise-1.2.0.899.x86_64.iso

ISE installation - reimaging issue

Muhammad Munir — Wed, 18 Sep 2013 08:04:21 GMT

Hi Mudasir,

Regarding Cisco ISE full deployment, please go through this link:

http://www.cisco.com/en/US/docs/security/ise/1.2/installation_guide/ise_ig.html