topic Getting Error:Failed to start DB! in Network Access Control

Getting Error:Failed to start DB!

sachpednekar — Mon, 11 Mar 2019 02:40:28 GMT

Hi,

While installing ISE 3395 i am getting error failed to start DB!

Database is not available withintimeout of 240 seconds.this could be reason of incorrect network configuration or lack of resources on the appliance or VM, please fix the issue and run the folloing CLI to re-prime database

'application reset-config ise'

Thanks,

Sachin

Getting Error:Failed to start DB!

Tarik Admani — Mon, 15 Oct 2012 20:21:28 GMT

Sachin,

I have seen this issue when dns isnt configured. Please check dns for the ISE hostname (both A and PTR records).

Thanks

Tarik Admani
*Please rate helpful posts*

Getting Error:Failed to start DB!

sachpednekar — Tue, 16 Oct 2012 13:54:43 GMT

Yes, they are not talking to DNS Server as they are installed in LAB, LAB network does not communicate with Production.

If I configure everything in Lab i.e. Hostname, IP address, Domain Name, Name server, NTP server and then put them in to production whether it will work? Or tell me the best way to configure them!

Below are the steps which I am thinking to perform

Sr No	Task	Location
1	IP Address Assignment to all 5 Boxes	Lab
2	Shipment of all Appliances to the respective site	Site
3	ISE Appliances Licensing	Site
4	Active Directory Integration	Site
5	Certificates(CA & CSR)	Site
6	End Points and Authenticator configuration on ISE Appliances	Site
7	Authentication and authorization Policies	Site
8	Testing	Site
9	Deployment	Site

Getting Error:Failed to start DB!

Tarik Admani — Tue, 16 Oct 2012 15:00:46 GMT

When I stage the ISE appliances for my projects I have a virtual machine with a dns zone for a customer that i am working with, from there I can get the database started, certificates installed. along with steps 3, 6, and 7. Instead of using AD to build the policies I use internal groups and replace them with AD groups when devices are installed at the customer site.

Thanks,

Tarik Admani
*Please rate helpful posts*

Hi all,i'm getting the same

balepe — Sat, 03 May 2014 10:17:55 GMT

Hi all,

i'm getting the same error on my ISE 3415-K9 Appliance in the Lab-environment.

what is actually the recommendation or the origin of the error.

is ist cause by the lack of FQDN resolution?

if yes! then this would mean that installing the appliance onsite, i wont get the error since the DNS-Resolution will be given.

thanks in advance for your post.

i fixed the problem in my

balepe — Wed, 07 May 2014 14:02:50 GMT

i fixed the problem in my case by:

setting up my C3750 as NTP and NDS Server

the C3750 could Sync the Time with the ISE sind the ISE was showing this:

Cisco Identity Services Engine

---------------------------------------------

Version : 1.2.0.899

Build Date : Wed Jul 24 09:37:31 2013

Install Date : Mon Mar 1 05:40:56 1993

after doing that, i could successfully retart the DB by setting up following command:

“application reset-config ise”.

Regards

Balepe