topic ISE delete command 80 character limitation in Network Access Control

ISE delete command 80 character limitation

Simon Rittner — Mon, 11 Mar 2019 02:44:28 GMT

Hello Guys,

one of our customers did a backup to local disk on the ISE. Later he tried to remove the file on the ISE node by running the delete command. Unfortunately the name of the file exceeded the 80 character limitation of the CLI delete command.

Is there any other opportunity to get rid of the backup file?

ISE delete command 80 character limitation

Tarik Admani — Thu, 01 Nov 2012 15:53:45 GMT

how many characters are you over when you try to run this command?

Thanks

Tarik Admani
*Please rate helpful posts*

ISE delete command 80 character limitation

Simon Rittner — Thu, 01 Nov 2012 20:02:20 GMT

Hello Tarik,

thanks for your reply. We are marginally over the the maximum - in fact just the full path is over the limit and not the file name itself.

disk://

--> a total of 80 characters

Thanks

Simon

ISE delete command 80 character limitation

nspasov — Thu, 01 Nov 2012 22:43:56 GMT

I haven't run into this before but it sounds like a bug Here is what I would recommend:

1. ISE 1.1.2 just came out so you can upgrade your system and see if that takes care of the problem

2. If #1 does not fix the issue then you should probably contact TAC and get a root patch installed to gain root level access to the system. Once you have root access you can do pretty much whatever you like including deleting that file. After the issue is resolved request the TAC engineer to file a defect with the development team so they can fix this in the future release

Thank you for rating!